Loading ...
Loading ...
Loading ...
SERVICE AN ADJUSTMENTS
TRANSAXLE SHIFTER LINKAGE AND AD-
JUSTMENT (See Figs. 30 and 31)
The transaxle should be in neutral when the gear shiftlever
is inthe neutral (N) (lock gate) pesition_ The adjustment is
preset at the factory; however, if adjustment is needed,
proceed as follows:
o Make sure transaxle is in neutral (N)o
° Loosen two locknuts on tie rod.
• Turn center rod until gearshift lever falls into neutral
lock gate on fender console.
• Tighten Iocknuts securely.
LOCKGATE
FIGo 30
LOCKNIJTS
CENTER ROD
TRANSAXLE
FIG. 31
TO START ENGINE WITH A WEAK BATTERY
See Fig. 32)
CAUTION: Lead-acid batteries gener-
ate explosive gases. Keep sparks, flame
and smoking materials away from bat-
teries. Always wear eye protection
when around batteries.
If your battery is too weak to start the engine, it should be
recharged_ If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT: YOUR TRACTOR IS EQUIPPED WITHA
12 VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER
VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE
GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER VEHICLES.
TO ATTACH JUMPER CABLES -
= Connect each end of the RED cable to the POSITIVE
(+) terminal of each battery, taking care not to short
against chassis,
° Connect one end of the BLACK cable to the NEGA -
TIVE (-) terminal of fully charged battery.
• Connect the other end of the BLACK cable to good
CHASSIS GROUND, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
. BLACK cable first from chassis and then from the fully
charged battery
° RED cable last from both batteries.
O
L,H. PANEL
BOLT
FIG. 32
24
Loading ...
Loading ...
Loading ...