DXPW4035 Instruction Manual

Loading ...

ENGLISH

Connect Spray Wand to

SprayGun

Thread the spray wand into the end of

the spraygun.

Connect QC Nozzles to

SprayWand

Pull quick connect coupler back and

insert nozzle. Release quick connect

coupler and twist nozzle to make sure

it is secure incoupler.

Turn Water Faucet

CompletelyOn

Do not run the unit without water

supply connected and turned on. Use

Cold WaterOnly.

Release Air from System

Release all air from pump and high

pressure hose by depressing trigger

until a steady stream of water is

present. Approximately 30seconds.

Verify the Engine Switch is

turned to the ON Position

Place the fuel valve lever in

the ONposition.

30 S

OFF

Move the choke to the

CLOSEDposition

Pull the Recoil Starter Grip

Pull the recoil starter grip to start

theengine.

Move the choke to the

OPENposition



WARNING: This Guide is not a substitute for reading the operator’s manual. User must read and understand operator’s

manual before using thisproduct.

Engine

Refer to the engine instruction manual for location and operation of other enginecontrols.

Pump

The Pump was filled with oil at the factory. The preferred oil is SIMPSON® Premium Pump Crankcase Oil. If this oil is not

available, an SAE 15W-40 oil may be used. Change the pump oil after the first 50hours of operation and every 100 hours

thereafter, or every 3months.

Loading ...

Dewalt DXPW4035 4000 Psi At 3.5 Gpm Cold Water Gas Pressure Washer Powered By Honda With Triplex Pump