Loading ...
Loading ...
Loading ...
ENGLISH
11
OFF
ON
Fig. M
8
12. Place the fuel valve lever
13
in the ONposition.
13. If the engine is cold, move the choke
12
to the CLOSED
position asshown.
Fig. N Fig. O
13
12
WARNING: Risk of unsafe operation. Pull starter
grip slowly until resistance is felt. Then pull starter
grip
9
rapidly to avoid kickback and prevent hand or
arminjury.
NOTE: Do not allow the starter grip to snap back. Return it
gently byhand.
WARNING: Risk of unsafe operation. If engine does
not start after two pulls, squeeze trigger of gun to
relieve pump pressure. Pull starter cord slowly until
resistance is felt. Then pull cord rapidly to avoid
kickback and prevent hand or arminjury.
NOTE: If the oil level in the engine is low, the engine will
not start. If the engine does not start, check the oil level and
add oil asneeded.
14. As the engine warms up, move the choke to the
openposition.
Fig. P Fig. Q
24
15. Depress trigger on gun to start waterflow.
WARNING: Do not allow the unit to run for
more than two minutes without the gun trigger
being pulled. This could cause overheating and
damage to the pump. When the temperature
inside the pump rises too high, the thermal relief
valve will open and release a spray of water from
the pump to lower the internal temperature. The
valve will thenclose.
WARNING: Risk of unsafe operation. Stand on a
stable surface and grip gun/wand firmly with both
hands. Expect the gun to kickback whentriggered.
16. Release trigger to stop waterflow.
DANGER: Risk of injury from spray. Engage the
trigger lock
24
when gun is not in use to prevent
accidentalspraying.
17. Adjust spray for the task being performed by changing
quick connect nozzle. Refer to Spray WandNozzles.
Shutting Down (Fig. R, S)
1. If chemicals were applied, place the chemical hose
into a container of clean water and draw clean
water through chemical injection system to rinse
systemthoroughly.
NOTICE: Risk of property damage Failure to do so
could cause damage to thepump.
2. Place the engine ON/OFF switch
8
to the OFFPosition.
3. Place the fuel valve lever
13
in the OFFposition.
OFF
ON
Fig. R
Fig. S
8
NOTICE: Risk of property damage. Never turn water
supply off while pressure washer engine is running or
damage to pump willresult.
4. Turn water sourceoff.
5. Pull trigger on spray gun to relieve any water pressure in
hose or spraygun.
6. Refer to Storage for proper storageprocedures.
MAINTENANCE
WARNING: Risk of burning. When performing
maintenance, you may be exposed to hot surfaces,
water pressure or moving parts that can cause serious
injury ordeath.
WARNING: Risk of fire. Always disconnect, spark
plug wire, let the engine cool and release all water
pressure before performing any maintenance
or repair. The engine contains flammable fuel.
Do not smoke or work near open flames while
performingmaintenance.
To ensure efficient operation and longer life of your
pressure washer, a routine maintenance schedule should
be prepared and followed. If the pressure washer is used
in unusual conditions, such as high temperatures or
dusty conditions, more frequent maintenance checks will
berequired.
Engine
Consult the engine instruction manual for the manufacturer's
recommendations for any and allmaintenance.
Loading ...
Loading ...
Loading ...