Loading ...
Loading ...
Loading ...
NOTE: if the cage needs to be removed, because the
float is placed in the wrong way, use a slotted
screwdriver and apply the slotted end to one of the
cage tabs. Push in on the tab and miftthe cage up. Tilt
the cage slightgy away from the open slot to release
the other two tabs. Pull the cage away from the lid.
To replace foNow float cage assembly instructions.
I
rifler assembly
1. Carefully put the filter onto the cage by sliding it over
the center ring covering the 3 slots until it rests on the
:/o/__.................FILTERNUt
FILTER PLATE
2. Place the hole of the filter plate over threaded screw
of the cage.
FILTER
3, Gently push on the filter plate in order for the rubber
ring ol the filter to seat inside the circular channel of
the fitter p{ate.
4. Place filter nut onto threaded screw and tighten it
down. Finger tight only.
NOTE: Lever of nut should be away from plate as
shown,
CAUTION: Do not overtighten as this will deform
or crack the filler plate or cage. Nut lever should
be away from plate.
5. Before replacing the lid check to see if filter nut is
tight, it should be tight enough that filter cannot
turn easily. Finger tight only.
6. Put the top back on the dust drum by lining up the
vacuuming opening of the top with the drain of the
dust drum and push down on both handles at once.
Make sure that the locking tabs are snapped in
place to prevent the lid from coming off.
/t :_ ,\\ _PUSH
.
Loading ...
Loading ...
Loading ...