Loading ...
Loading ...
Loading ...
10
8.3 Stock Stop
The stock stop is used for making multiple cuts of
the same length.
1. Insert the stock stop rod (A, Figure 5) into the
hole at the front of the base as shown.
Figure 5
2. Secure the rod by tightening the socket set
screw (B, Figure 5) with a 3mm hex wrench.
3. The stock stop is moved along the rod by
loosening the socket set screw (C, Figure 5)
with a 4mm hex wrench. The stock stop can
be reversed on the rod to accept slightly longer
lengths of workpieces. Tighten the socket set
screw (C, Figure 5) when the stock stop is
positioned as desired.
The stock stop will mount into the hole at the front
or the back of the band saw, depending upon the
angle of cut being made (explained more fully
under “Miter Cuts”).
9.0 Grounding Instructions
9.1 General Information
Electrical connections must be
made by a qualified electrician in compliance
with all relevant codes. This machine must be
properly grounded to help prevent electrical
shock and possible fatal injury.
This machine must be grounded. In the event of a
malfunction or breakdown, grounding provides a
path of least resistance for electric current to
reduce the risk of electric shock.
This band saw is pre-wired for 115 volt and is
equipped with an electric cord having an
equipment-grounding conductor and a grounding
plug similar to that shown in Figure 6. The plug
must be inserted into a matching outlet that is
properly installed and grounded in accordance with
all local codes and ordinances.
Do not modify the plug provided. If it will not fit the
outlet, have the proper outlet installed by a
qualified electrician.
Figure 6
Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. The
conductor, with insulation having an outer surface
that is green with or without yellow stripes, is the
equipment-grounding conductor. If repair or
replacement of the electric cord or plug is
necessary, do not connect the equipment-
grounding conductor to a live terminal.
Check with a qualified electrician or service
personnel if the grounding instructions are not
completely understood, or if in doubt as to whether
the machine is properly grounded. Use only three
wire extension cords that have three-prong
grounding plugs and three-pole receptacles that
accept the machine’s plug.
9.2 115 Volt Operation
As received from the factory, your band saw is
ready to operate at 115 volt power, using an outlet
and a plug that look similar to those illustrated in
Figure 6.
A temporary adapter, which looks like the adapter
illustrated in Figure 7, may be used to connect this
plug to a two-pole receptacle as shown, if a
properly grounded outlet is not immediately
available. The temporary adapter should only be
used until a properly grounded outlet can be
installed by a qualified electrician.
Figure 7
Loading ...
Loading ...
Loading ...