Speed Queen DV6000WG 27 Inch Commercial Gas Dryer with 7 Cu. Ft. Capacity, Quantum Gold Pro Control, 5 Dry Cycles, Largest Door Opening, Reversible Door, Upfront Lint Filter, Durable Galvanized Steel Cylinder, and Integrated Meter Case: Coin Drop: Coin Bo

Owner Manual - Page 26

For DV6000WG.

PDF File Manual, 29 pages, Read Online | Download pdf file

DV6000WG photo
Loading ...
Loading ...
Loading ...
Troubleshooting
Try these troubleshooting tips before making a service call. They
may save you time and money.
Washer Symptom Possible Cause/Solution
Won’t Fill Make sure lid is closed.
Make sure power cord is plugged all the way into the electrical outlet.
Check the laundry room fuse or circuit breaker.
Insert coin(s) or card.
Make sure that the controls are properly set.
Make sure hot and cold water faucets are turned on.
Make sure drain hose is not kinked or twisted.
During the rinse portion of the cycle, the tub won’t fill with water. Instead, there is a
spray rinse.
Make sure that the last spin has been completed.
Clean the screens in the water mixing valve and the filter screens located at the faucet
end of the fill hoses. (Owner is responsible for service calls regarding cleaning of the
screens.)
Water is being siphoned from the washer during the cycle. Refer to the Installation
instructions to make sure that the drain hose has been properly installed.
The motor overload protector may have stopped the cycle. It will reset itself in two or
three minutes and restart the washer automatically.
Won’t Start Make sure lid is closed.
Make sure power cord is plugged all the way into the electrical outlet.
Check the laundry room fuse or circuit breaker.
Insert coin(s) or card.
Make sure that the controls are properly set.
The motor overload protector may have stopped the cycle. It will reset itself in two or
three minutes and restart the washer automatically.
Won’t Agitate Make sure lid is closed.
Make sure power cord is plugged all the way into the electrical outlet.
Check the laundry room fuse or circuit breaker.
Insert coin(s) or card.
The motor overload protector may have stopped the cycle. It will reset itself in two or
three minutes and restart the washer automatically.
Broken drive belt. Call the service person.
Have a qualified electrician check polarity and earth/ground. Refer to Electrical Re-
quirements section.
Table continues...
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
26 Part No. 205161EN
Loading ...
Loading ...
Loading ...