Loading ...
Loading ...
Loading ...
Questions?
Use this
problem
solver!
The Problem Solver
Custom Hood Insert
PROBLEM
FAN AUTOMATICALLY
TURNS ON AND CAN
NOT BE TURNED OFF
FAN DOES NOT
OPERATE WHEN
TURNED ON
FAN FALLSTO CIRCULATE
AIR OR MOVES AIR
SLOWER THAN NORMAL
FAN KEEPS GOING
OFF AND ON
LIGHT WILL NOT STAY
ON HIGH SETTING
THE HOOD CONTROLS
ARE NOT OPERATING
CORRECTLY
SEQUENTIAL PRESSES
OFTHE LIGHT OR FAN
BUTTONS WILL
SOMETIMES CHANGE
THE SETTING FROM THE
LOWEST SETTING-TO OFF-
TO THE HIGHEST SETTING,
OR FROM THE HIGHEST
SETTING-TO OFF-TO THE
LOWEST SETTING
WHEN PRESSING THE
POWER ON/OFF BUTTON
TO TURN ON THE LIGHT,
THE FAN COMES ON
INSTEAD
POSSIBLE CAUSE
The Sensor feature will automatically turn the fan on at the
HED setting if cooking temperatures become too hot. The fan
will stag on for a minimum of :3minutes and will then turn off when
temperatures cool to an appropriate level.
. A fuse may be blown or a circuit breaker tripped. Replace fuse or
reset circuit breaker.
. The power disconnect switch inside the hood may be switched off.
Remove the metal grease filters and flip the switch on.
Check to be sure the metal grease filters are clean. Clean the metal
grease filters (seethe Metal grease filters section). If cleaning
the filters does not correct the problem, call for service.
Sufficient makeup (replacement) air is required for exhausting
appliances to operate to rating. Check with local building codes,
which may require or strongly advise the use of makeup air. Visit
GEAppliances.com for available makeup air solutions.
The motor is probably overheating and turning itself off. Th is can
be harmful to the motor. Check to be sure the filters are clean. If off
and on cycling continues, call for service.
Use 120 volt, 50 watt halogen bulbs with a GU10 base and make sure
they are inserted securely. See the Light bulbs section.
Disconnect power to the hood by removing the fuse or turning the
circuit breaker off inthe home fuse box. Wait 30 seconds to allow the
hood controls to reset and then replace the fuse or move the circuit
breaker back on.
It is normal for the light and fan buttons to cycle around through the
settings so that you can easily set the controls to the desired setting.
For your convenience, it isnormal for the lights and fan to remember
their last setting when you press the Power On/Off button. Ifyou
want only the lights on, press the "FAN+" (or the "FAN -") button until
the fan is off. When you power the hood up next time, only the lights
will function.
Loading ...
Loading ...
Loading ...