Loading ...
Loading ...
Loading ...
5. Lift up the bulb cover.
1. Bulb cover
6. Remove the burned-out bulb by squeezing the wire clip
together, pulling to the right and lifting.
7. Replace bulb, using tissue to handle bulb, or wearing cotton
gloves. Do not touch bulb with bare fingers.
8. Close bulb cover.
9. Replace charcoal odor filter.
10. Slide the top of the vent grille into place. Push the bottom
until it snaps into place.
11. Plug in microwave oven or reconnect power.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the
cost of an unnecessary service call.
Nothing will operate
Has a household fuse been blown or has the circuit
breaker been tripped?
Replace the fuse or reset the circuit.
Is the appliance wired properly?
See Installation Instructions.
Oven will not operate
Is the door completely closed?
Firmly close door.
Is a spacer (on some models) attached to the inside of the
door?
Remove spacer, then firmly close door.
is the electronic oven control set correctly?
See "Microwave Oven Control" section.
On some models, is the Child Lock set?
See "Child Lock" section.
Is the magnetron working properly?
Try to heat 1 cup (250 mL) of cold water for 2 minutes at
100% cooking power. Ifwater does not heat, call for service.
See "Assistance or Service" section.
Oven makes humming noise
• This is normal and occurs when the power supply switches
the magnetron on and off.
Oven door looks wavy
•This is normal and will not affect performance.
Turntable will not operate
is the turntable properly in place?
Make sure turntable is correct-side up and is sitting securely
on the turntable support.
Is the turntable support operating properly?
Remove turntable. Remove and replace turntable support.
Replace turntable. Place 1 cup (250 mL) of water on the
turntable, then restart oven. If it still is not working, call for
service. See "Assistance or Service" section. Do not operate
the oven without turntable and turntable support working
properly.
Turntable rotates both directions
• This is normal and depends on motor rotation at beginning of
cycle.
Display shows messages
•Is the display showing ":"?
There has been a power failure or the clock time has been
turned off. See "Display" section to clear display. See "Clock"
section to reset the clock or to turn it on.
Is the display showing a letter followed by a number?
See "Display" section to clear. If it reappears, call for service.
See "Assistance or Service" section.
Display shows time countdown, but is not operating
•Is the Timer in use?
See "Timer" section.
•On some models, is the Demo Mode in use?
See "Demo Mode" section.
Tones are not sounding
•Aretones turned off?
See "Tones" section.
18
Loading ...
Loading ...