Loading ...
Loading ...
Loading ...
SERVgCE
'llrll IIIIIIIIIIII _ I I : I: _ IJ I I[_ t :
D ADJUSTN T$
TO ADJUST ATTACHMENT LIFT SPRING
(See Fig. 31)
• While holding spring bushing with wrench, loosen jam
nut°
o Turn adjustment bolt clockwise to extend spring and
reduce lift effort for heavier attachments,
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 33)
The throttle control has been preset at the factory and
adjustment should not be necessary, Check adjustment as
° Turn adjustment bolt counterclockwise for lighter at-
tachments,,
o Retighten jam nut against spring bushing.,
IMPORTANT: DO NOT ADJUST FOR MAXIMUM SPRING
TENSION WHEN USING LIGHT ATTACHMENTS SUCH
AS A MOWER. ADJUST LIFT LEVER SPRING TO AID IN
LIFTING ATTACHMENT. DO NOT OVERPOWER SPRING.
WHEN REMOVING ATTACHMENT, ALWAYS ADJUST
SPRING TENSION TO ITS LOWEST POSITION.
ADJUSTMENT
SPRING BUSHING
ATTACHMENT
JAM NUT LIFT SPRING
o o
FtGo31
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 32)
o Raise hood.
• Unsnap headlight wire connector'.
- Stand in front of tractoL Grasp hood at sides, tilt toward
engine and lift off of tractor.
- To replace, reverse above procedures.
iA
HEADLIGHT
HOOD
described below before loosening cable. If adjustment is
necessary, proceed as follows:
• With engine not running, move throttle control lever to
fast (,_) position_
° Check that speed control lever is against stop screw. If
it is not, loosen casing clamp screw and pull throttle
cable until lever is against screw. Tighten clamp screw
securely_
IDLE FUEL
ADJUSTING
NEEDLE
IDLE SPEED
ADJUSTING
SCREW
/
/
THROTTLE
CONTROL
CABLE
STOP
SCREW
CLAMP
SCREW
CHOKE
CONTROL
CABLE
FIG. 33
FIG. 32
26
Loading ...
Loading ...
Loading ...