Kenmore 3639524710 refrigerator

User Manual - Page 13

For 3639524710.

PDF File Manual, 16 pages, Download pdf file

Loading ...
Loading ...
Loading ...
8, If tape holds bottom drawer cover to drawer
supports, remove the tape_ Pull drawer partway out
Reach in, push the rear of the glass up and, at the same
time, back, until itclears front-corner retainers
9, Tilt and remove the cover
10. Tilt and remove the drawer
After cleaning, replace drawers and covers in reverse
order Reinstall the gasket at the rear of the top drawer
Fit the end of the plastic
drawer support into the
slot on the gasket, with the
rubber gasket flap facing
you Make sure the gasket
snaps into place.
Then replace the light panel
by hanging top of panel on
upper pins and pushing in
at bottom
Drain Opening in Freezer Compartment
When cleaning, remove
the freezer bin and flush
a solution of baking soda
(one teaspoon) and two
cups of hot (not boiling)
water through the drain
line with the help of a
meat baster. This will
help eliminate odor and
reduce the likelihood of a clogged drain line
if drain becomes clogged, use a meat baster and
baking-soda-and-water solution to force the clog through
the drain line,
Condenser
The condenser is located
behind the base grille For
most efficient operation,
remove the base grille
(see page 3) and sweep
away or vacuum up dust
that isreadily accessible
Forbest results, use a brush
specially designed for this purpose_ It isavailable at your
Sears store or service center. This easy cleaning
operation should be done at least once a year.
Behind Refrigerator
Take care moving your refrigerator away from the wall,
All types of floor coverings can be damaged, particularly
cushioned coverings and those with embossed surfaces
Pullthe refrigerator straight out and return it to position by
pushing it straight in Moving refrigerator in a side direction
may damage floor covering or refrigerator
Light Bulb Replacement
Unplug refrigerator before changing alight bulb_
Fresh Food Compartment-Upper Light
1. Pull bottom of light
panel down about 1/4"-
just enough to disengage
lip at rear from grooves
in retainers on rear wall
2. Lift panel to disengage
top from tabs on control
housing, and remove panel,
After replacing with same
size bulb, reinstall panel
(hang top on tabs; pull
bottom down and push
it back, and release it
to let lip engage grooves
one on each side
eachside
Fresh Food Compartment--Lower Light
(on models so equipped)
This light is located behind a shield at the rear of
the fresh food compartment
1. Grasp the top edge of the shield and lift it up
and forward to free its top edge
2. After replacing with same size bulb, hook the top
of the shield back in place
Freezer Compartment
1_Remove shelf just below
light panel (Shelf will be
easier to remove if itis
emptied first.)
2. Pull plastic light panel toward you (It will bend to
free tabs from grooves )
3. After replacing with same size appliance bulb,
reinstall panel and shelf
13
Loading ...
Loading ...
Loading ...