Loading ...
Loading ...
Loading ...
Transferring Files
Once connected to HyperDeck Extreme 8K HDR you can transfer files as you normally would
with your ftp program. Most ftp applications have a drag and drop interface, but check your
particular application for the appropriate method.
You can also transfer any file to and from a HyperDeck Extreme 8K HDR, but it’s worth noting
that any files you intend to play back from the HyperDeck will need to conform to your
HyperDeck’s supported codecs and resolutions. You can find a list of supported codecs in the
‘Blackmagic HyperDeck Setup’ section of this manual.
TIP You can transfer files over a network while your HyperDeck Extreme 8K HDR is
recording. HyperDeck Extreme 8K HDR will automatically adjust transfer speeds to
make sure recording is not affected.
Developer Information
Blackmagic HyperDeck Ethernet Protocol
Version 1.10
The Blackmagic HyperDeck Ethernet Protocol is a text based protocol accessed by connecting
to TCP port 9993 on HyperDeck Extreme 8K HDR. If you are a software developer you can use
the protocol to construct devices that integrate with our products. Here at Blackmagic Design
our approach is to open up our protocols and we eagerly look forward to seeing what you
come up with!
You can connect to your HyperDeck recorder using the HyperDeck Ethernet Protocol using a
command line program on your computer, such as Terminal on a Mac and putty on a
Windows computer.
The HyperDeck Ethernet Protocol lets you schedule playlists and recordings. The following is
an example of how to For example, to play 7 clips from clip number 5 onwards via the
HyperDeck Ethernet Protocol. If your recorder is installed out of reach, you can also turn on the
‘remote’ feature via ethernet.
On a Mac
1 Open the Terminal application which is located with the applications > utilities folder.
2 Type in “nc” and a space followed by the IP address of your HyperDeck Extreme 8K
HDR another space and “9993” which is the HyperDeck Ethernet Protocol port number.
For example type: nc 192.168.1.154 9993. The Protocol preamble will appear.
3 Type “playrange set: clip id: 5 count: 7” and press ‘return’.
If you look on the timeline on the front panel of the HyperDeck Extreme 8K HDR, you
will see in and out points marked around clips 5 through the end of clip 11.
4 Type “play”. Clips 5 through 11 will now play back.
5 To clear the playrange, type “playrange clear”
6 To exit from the protocol, type ‘quit’.
75Developer Information
Loading ...
Loading ...
Loading ...