Loading ...
Loading ...
Loading ...
STEP 2: Attach Handlebar
1. Attach the two legs of the handlebar
support (A, Fig. 2-2) loosely to the inner
sides of the tiller frame using two 3/8"-16
x 3/4" hex hd. screws (B), two 3/8" flat
washers (C) and 3/8"-16 hex Iocknuts (D).
2. Using using two 5/16"-18 x 1-1/2" hex
hd. screws (G), 5/16" split Iockwashers
(H) and 5/16"-18 hex nuts (I), loosely
attach the the handlebarsupport (A) using
the upper holes.
3. There are three height adjustment holes
in the two handlebarsupport brackets. E
& F, Fig.2-2). Use a setting that will
position the handlebarsat approximately
waist level when the tines are 3"-4" into
the soil. Looselyattach the handlebar
support bracketsto the outside of the
handlebarassembly (K) using two 5/16"-
18 x 1-1/2" screws (G), 5/16" split lock-
washers (H) and 5/16"-18 hex nuts (I).
NOTE:If a support bracket will not move,
loosen attaching screw (J) and nut.
IMPORTANT:The support brackets must
be assembledto the outsideof the
handlebarassembly.
4. Tighten all handlebar mounting
hardware securely.
STEP 3: Move Tiller Off Shipping
Platform
To move the tiller without the engine
running, put the wheels in their
FREEWHEELposition, as described below.
1. Usea sturdy block to raise onewheel
off the ground.
2. Removethe hairpin cotter (L, Fig. 2-3)
and wheel drive pin (M). Slide the wheel
inward on the wheel shaft (N). Reinstall
the wheel drive pin and hairpin cotter
through the wheel shaft only (not through
the wheel hub). Repeatwith the other
wheel.
3. Using the handlebaras a lever, roll the
tiller to a flat area.
IMPORTANT:Before starting the engine,
the wheels must be placed in their WHEEL
DRIVEposition (pins through wheel hubs
and wheel shaft). This procedure is
described in "Wheel Drive Pins" in
Section2: Assembly
Fig. 2-2: Attach handlebar.
Fig. 2-3: Wheel in FREEWHEELING
position (wheel drive pin throughwheel
shaftonly).
Loading ...
Loading ...
Loading ...