Loading ...
Loading ...
Loading ...
OPERATION
Avoidworkingonhotsurfacesorindirectsunlighttominimizethechancesofthechemicaldamaging
paintedsurfaces.Damagemayoccurtopaintedsurfacesifthechemicalisallowedtodryonthesurface.
Holdthenozzlefarenoughawayfromsurfacetopreventdamagetothesurface.
2.Allow chemicalto remainonthe surfacefor a short time beforerinsing.
3. Rinsewith cleanwaterunder highpressure.Onaverticalsurface,first rinsefrom the bottomup,then
rinsefrom top down. Holdnozzle6to 8 inchesfrom thework surfaceat a45° angleusingtheflat sprayas
a peelingtool ratherthana scrub brush.
APPLICATION OF WAX
1. Immediately after cleaning, apply wax. Place injection tube in container of wax.
2. Apply the wax sparingly in an even layer. Apply to wet surfaces from bottom up for even distribution and to
avoid streaking.
3. Remove the suction tube from the wax bottle rinse off the surplus wax.
NOTE: If surplus wax is not removed, a hazy finish may result.
4. Wipe dry to reduce water spotting.
END OF OPERATION
When you have completed use of chemical injectionsystem, remove tube from container. Continue to run in
low pressure position and inject clean water through the tube and injection system by placing end of tube in a
container of clean water. Continue to run until it is thoroughly cleaned.
MAINTENANCE
Connections
Connection on pressure washer hoses, gun and spray wand should be cleaned regularly and lubricated with
the manufacturers recommended grease to prevent leakage and damage to the O-rings.
NOZZLE
Cloggingofthe nozzlecausesthe pumppressureto betoo high,cleaningisimmediatelyrequired.
A nozzle cleaner must only be used when the spray
wand is disconnected from the gun or personal injury
may occur.
1. Seperate the wand from the gun.
Loading ...
Loading ...
Loading ...