Loading ...
Loading ...
Loading ...
8
3
TOOLS NEEDED TO BOLT SAFE
MOUNT THE SAFE
BOLTING DOWN YOUR SAFE
1.Drill
2.Marker pen
3.Expansion screws (included)
Step1:
Place the safe at the installation place (wall or floor), mark the drilling spots on
the wall/floor from the inside pre-drilled holes.
Step2:
Remove the safe and drill a about 10 mm hole in the wall or floor with drill bit.
Step3:
Position safe in place and install screws through safe in to the holes.Tighten
screws.
NOTICE：This safe has 6 pre-drilled holes, 4 pre-drilled holes in the back and
2 pre-drilled holes in the bottom (The bottom pre-drilled holes are in the hidden
compartment, you need to remove the blanket on the bottom of the hidden
compartment to find it), you can mount the safe on the wall or floor according to
your needs.
Step 1：Open the door with the key
1.Down slide the keyhole cover to expose the emergency
keyhole.
2.Insert the emergency key, turn it counterclockwise to the
limit, and hold on it.
3.Then rotate the knob clockwise to open the door.
NOTICE: 1.When you rotate the knob to open, you must have the key fully inserted and
turned counterclockwise to the limit, keeping the key until the safe unlocked and opened.
2.Use the key to unlock, the led light will not light up.
3.Please keep the keys in a secure place, do not lock the keys inside the safe.
Step 2：Install Battery
1. After first opening, keep the safe open and locate the battery case, prepare 4
brand-new AA 1.5 Volt alkaline batteries (not included).
2.Remove the internal battery case cover and install the 4 AA batteries by matching
the + & - electrode.
NOTICE: 1. Rechargeable battery is not recommended as it may destroy the
internal electronic components of your safe.
2. Please use brand-new batteries, do not mix used batteries with new batteries.
3. After opening the door, if the safe
beeps 6 times in a row, it means the batteries
are out of power, please replace the batteries.
SET UP THE CODE
1 23
456
789
0
*
#
1 23
456
789
0
*
#
Loading ...
Loading ...
Loading ...