Loading ...
Loading ...
Loading ...
11
3. Fit gas regulator supplied, into gas supply line as close to appliance as possible.
For G592, regulator connection is ½" BSP female. Connection on unit is ½" BSP male.
For G593 / G594 / G596 / G598 regulator connections are ¾" BSP female. Connection on unit is
¾" BSP male.
(Refer to ‘Specifications’ section for gas supply location dimensions).
NOTE: Gas pressure regulator provided with this appliance is convertible between Natural Gas
and LPG as shown in ‘Gas Conversion Section’ in this manual.
Ensure regulator is converted to the correct gas type that the appliance will operate
on. Regulator outlet pressure is fixed ex-factory for gas type that regulator is
converted to and it is NOT to be adjusted.
4. A suitable joining compound which resists the breakdown action of LPG must be used on every gas
line connection, unless compression fittings are used.
NOTE: A manual isolation valve must be fitted to the individual appliance supply line.
5. Correctly locate appliance into its final operating position and using a spirit level, adjust legs so that
unit is level and at the correct height.
6. Connect gas supply to appliance.
7. Check gas operating pressure is as shown in ‘Specifications’ section.
8. Check all gas connections for leakages using soapy water or other gas detecting equipment.
NOTE: Measure burner operating pressure at the
manifold test point with one burner for G592
and G593 Models or two burners for other
models, operating at full setting. Operating
pressure is ex-factory set and not to be
adjusted, apart from when converting
between gases, if required. (Refer to ‘Gas
Conversion’ section for details).
1. Before leaving the new installation;
a. Check the following functions in accordance with operating instructions specified in ‘Operation’
section of this manual.
Light the Pilot Burner.
Light the Main Burner.
Check Low Fire Burner Operation.
Check High Fire Burner Operation.
b. Ensure operator has been instructed in the areas of correct lighting, operation, and shutdown
procedure for this appliance.
2. This manual must be kept by the owner for future reference and a record of
Date of Purchase
,
Date
of Installation
and
Serial Number of Unit
recorded and kept w ith this manual. (These
details can be found on the rating plate attached to underside of R/H side, front hob
lower trim.
NOTE: If it is not possible to get the appliance to operate correctly, contact the suppler of
this appliance.
Fig 3
Manifold
Test Point
DO NOT USE A NAKED FLAME TO CHECK FOR GAS LEAKAGES.
Loading ...
Loading ...
Loading ...