Loading ...
Loading ...
Loading ...
NEVER place items that might tempt children to climb,
such as toys and remote controls, on the top of the
television or furniture on which the television is placed.
If the existing television set is going to be retained and
relocated, the same considerations as above should be
For added protection for your device receiver during a
lightning storm, or when it is left unattended and
unused for long periods of time, unplug it from the
power outlet and disconnect any antenna or cable
system. This helps prevent property damage and
personal injury from lightning and power line surges.
Power lines
An outside antenna system should not be located in the
vicinity of overhead power lines or other electric light or
power circuits, or where it can fall into such power lines
or circuits. When installing an outside antenna system,
take extreme care to keep from touching such power
lines or circuits as contact with them might be fatal.
Handling the LCD panel
Your TV’s screen is made of glass. Do not drop your TV
or hit, jolt, or press hard against the LCD panel. If the
screen breaks, be careful of broken glass.
If the LCD panel is broken, make absolutely sure that
you do not touch the liquid in the panel. This may
cause skin inflammation.
If the liquid gets in your mouth, immediately gargle,
rinse, and consult with your doctor. Also, if the liquid
gets in your eyes or touches your skin, consult with
your doctor after rinsing for at least 15 minutes or
longer in clean water.
Replacement parts
When replacement parts are required, make sure that
the service technician uses replacement parts specified
by the manufacturer that have the same characteristics
as the original part. Unauthorized substitutions may
result in fire, electric shock, personal injury, or other
Safety check
After completing any service or repair to this device, ask
the service technician to perform routine safety checks
to determine that your TV is in correct operating
Power source
Operate your TV only from the type of power source
indicated on the marking label. If you are not sure of the
type of power supplied to your home, consult an
electrician or your local power company.
These servicing instructions are for use by qualified
service personnel only. To reduce the risk of electric
shock, do not perform any servicing other than that
contained in the operating instructions unless you are
qualified to do so.
Damage requiring service
Unplug this TV from the power outlet and refer
servicing to qualified service personnel under the
following conditions:
When the power supply cord or plug is damaged or
If liquid has been spilled or objects have fallen into
your TV.
If your TV has been exposed to rain or water.
If your TV does not operate normally by following the
operating instructions. Adjust only those controls
covered by the operating instructions because
incorrect adjustment of other controls may result in
damage and will often require extensive work by a
qualified technician to restore your TV to its normal
If your TV has been dropped or damaged in any way.
When your TV exhibits a distinct change in
Outdoor antenna grounding
If an outside antenna or cable system is connected to
your TV, make sure that the antenna or cable system is
grounded to provide some protection against voltage
surges and built-up static charges. Article 810 of the
National Electrical Code, ANSI/NFPA No. 70, provides
information with respect to correct grounding of the
mast and supporting structure, grounding of the lead-in
wire to an antenna discharge unit, size of grounding
conductors, location of the antenna-discharge unit,
connection to grounding electrodes, and requirements
for the grounding electrode.
Note to CATV system installer
Article 820 of the National Electrical Code, ANSI/NFPA
No. 40 provides guidance for correct grounding.
Specifically, it states that the cable ground must be
connected to the grounding system of the building as
close to the point of cable entry as practical.
Antenna lead-in wire
Grounding clamp
Antenna discharge
Ground clamps
Power service
grounding electrode
Electric service
Loading ...
Loading ...
Loading ...