Loading ...
Loading ...
Loading ...
8
5.0 Setup and assembly
5.1 Unpacking
Separate all parts from the packing material. Check
each part against sect. 5.2, Carton contents, and
make certain that all items are accounted for.
(Check grinder first to verify if any parts have been
pre-mounted.) Notify your dealer or JET if parts are
missing or there is shipping damage. Do not discard
packing material until grinder is assembled and
operating properly.
5.2 Carton contents
Refer to Figure 5-1.
1 Bench Grinder with wheels (not shown)
1 Spark guard, left – A
2 Lock knobs – B
1 Spark guard, right – C
1 Eye shield bracket, left – D
2 Truss head screws, 1/4 x 1/2 – E
1 Eye shield bracket, right – F
2 Eye shield plates – G
4 Hex cap screws, 5/16 x 3/4 – H
4 Flat washers, 5/16 – J
4 Pan head screws, 3/16 x 3/8 – K
4 Hex cap screws 1/4 x 3/8 – L
6 Flat Washers 1/4 – M
2 Lock Washers 1/4 – N
1 Tool rest, left – O
1 Tool rest, right – P
2 Eye shields – R
1 Operating Instructions and Parts Manual
1 Product registration card
5.3 Tools required for assembly
10mm and 12mm, or adjustable, wrench
#1 or #2 cross-point (Phillips) screwdriver
The JBG-W series Grinder requires only assembly
of eye shields and tool rests. Additional tools may
be needed for fastening the grinder to a workbench
or stand. For your safety, do not plug the grinder into
a power source until all assembly and adjustments
are complete.
Be sure that grinder is
unplugged and power switch is in OFF position.
Do not plug in grinder to power until it is
inspected for shipping damage and fully
assembled. Failure to comply may cause
serious injury.
Do not operate grinder without
all guards and shields in place and in working
order. Failure to comply may cause serious
injury.
Chipped or cracked wheels can
break up and cause serious damage to grinder
and/or severe injury to operator. Regularly
inspect wheels for damage.
Figure 5-1: carton contents
Loading ...
Loading ...
Loading ...