Loading ...
Loading ...
Loading ...
8
Programming Your Remote
1. Manually turn on the device you
wish to control.
NOTE: The Auto Code Search process
cannot be used for devices without
power ON/OFF capability. Use the
Direct Code Entry method in these
cases.
2. Press and hold down the SETUP
button on the remote until the red
light on the remote control turns on.
Release the SETUP button. The red
light will remain on.
NOTE: The red light will either be a
small light at the top of the remote or
the power ON/OFF button.
3. Press and release the device button
on the remote for the type of device
you wish to control, (for example TV,
DVD, STRM, AUX). The red light will
blink once and remain on.
4. With the remote pointed at the
device, press and release the
POWER button on the remote. The
remote will send 10 dierent codes
to the device. The red light will blink
once for each code and remain on
after sending the 10 codes.
Did the device turn o?
• If YES, go to Step 5.
• If NO, repeat Step 4 to test the
next 10 codes.
5. Manually turn the device back on.
6. With the remote pointed at the
device, press and release the
VOL
button. The remote will
re-send the rst code of the 10
codes from Step 4. The red light will
blink once and remain on.
Did the device turn o?
• If YES, you have found a code for
the device. Press and release the
same device button you pressed
in Step 3. This will store the code
in the remote. Go to Step 7.
Loading ...
Loading ...
Loading ...