Loading ...
Loading ...
Loading ...
How to Use the Reversible,Inlet Grille
1. if you want to pull out the filter upward,
open the inlet grille slightly. Turn inside out
the front grille.
Disassemble the inlet grille from the front
grille with separating the hinged part by
inserting a "--" type screw-driver tip.
Rotate the inlet grille 180 degrees and
insert the hooks into the lower holes of front
grille
Then, insert the filter. (See Fig,12, 13)
2 A_ach the front grille to the cabinet by
inserting the tabs on the grille into the tabs
on the front of the cabinet, Push the grille in
until it snaps into place (See Fig,14)
!
7Fig. 12
Fig. 13
3. Lift the inlet grille and secure it with a type
A screw through the front grille.
(See Fig. 15)
4 if you want to pull out the filter downward,
use the reversible inlet grille without
change.
(The grille is already assembled for that
way,)
Bectrical Data
Fig, 14
Fig, 15,
Line Cord Plug Use Wall Receptacle Power Supply
......._ I[)o not ur'der any
_T J z/ circumstances out
-./.._ or remove the Use 15 AM P time
>-_J I grounding prong delay fuse or circuit
Urom the plug,
i breaker.
Power supply €oid with
3oprong grounding plug
USE OF EXTENSION CORDS
Because of potential safety hazard& we strongly discourage the use of an extension _rd. However, if you wish to
use an extension cord, use a CSA certifiediUL-listed 3-wire (grounding) extension _rd, rated 15A, 125V.
Standard 125V, 3-wire grounding
r_eptacle rated 15A, 125V AC
Loading ...
Loading ...