Loading ...
Loading ...
Loading ...
10
Using Your Steam Cleaner
Using Your Steam Cleaner
Relling the Boiler During Use
When water in the boiler runs out, steam will stop emitting from the Steam
Cleaner. To rell the Boiler with water, follow the steps below:
• Switch off the Steam Cleaner by depressing the Power Switch and
unplug the appliance from the power outlet.
• Carefully and slowly turn the Boiler Cap counter-clockwise. If a hissing
sound is heard, residual steam and pressure remain in the Boiler. Wait
until the last of the steam and pressure escapes and the hissing stops
before removing the Boiler Cap.
• Take care of where the Boiler Cap is placed as the underside of the
cap is very hot. Ensure there are no children present who may pick up
the hot cap and cause burns to themselves.
• Allow the Steam Cleaner to cool for at least 5 minutes before relling
with water.
• Rell the Boiler with a maximum of 1.2 litres (2 pints) of water using the
Filler Funnel. (Note: only use the Filler Funnel supplied. Its nozzle is made
from a hear resistant material to prevent it from melting when lling a
hot boiler. Other plastic funnels can melt and become welded to the
inside of the boiler spout, voiding the product’s warranty).
• Be extremely careful when relling with water, as the interior of the
Boiler is very hot. Water may spurt out as hot water or hot steam
causing burns.
• Do not overll the Boiler, excess water in the Boiler will be ushed out
of the unit, resulting in wet oors or wet surfaces when cleaning. Dry
steam will only emit if the Boiler is not overlled.
• Replace the Boiler Cap by turning it clockwise. Do not over-tighten the
Boiler Cap, nger tight is sufcient.
• Turn on the Power Switch.
• The Steam Cleaner will heat up, produce steam and the Boiler will
become pressurised.
• When the green Steam Ready Light turns on the Steam Cleaner is
ready to use. Note: the green Steam Ready Light may turn on and off
during use, this is normal and not a fault.
• If using cold water, heating time is about 6-7 minutes. Using hot water
will reduce the heating time.
10
Turning Steam Cleaner Off
• To turn Steam Cleaner off, press the Power Switch and unplug the
electrical cord from the power outlet.
• Any remaining water can be left in the unit.
11
REMINDERS
• We recommend using distilled or demineralized water as the best way
to care for and utilize your Steam Cleaner.
• If tap water is too hard, use distilled or demineralized water to avoid the
risk of staining pale colored fabrics.
• Do not add detergents, perfumes, oils or other chemical substances.
WARNING: Do not open the Boiler Cap until there is no steam being
release from the Steam Gun. If the Boiler Cap is opened while
there is hot steam and pressure in the Boiler severe burns and injury
can occur. If the Boiler Cap is turned and steam/pressure start to
escape from the Steam Cleaner, unplug the Steam Cleaner from
the power outlet and let the unit cool down for at least 15 minutes
before attempting to rell or use the Steam Cleaner.
Loading ...
Loading ...
Loading ...