Dewalt D25604K Instruction Manual

Loading ...

English

SHOCKS Active Vibration Control® System

(Fig. A, F)

D25604, D25652, D25831, D25851

For best vibration control, hold the tool with one hand

on the main handle

4

and the other hand on the side

handle

3

. Apply just enough pressure so the damping

device on the main handle is approximately mid stroke. The

hammer only needs enough pressure to engage the active

vibration control. Applying too much pressure will not make

the tool drill or chip faster and active vibration control will

notengage.

Inserting and Removing Spline Drive

Accessories (Fig. C)

D25652, D25851



WARNING: Burn hazard. ALWAYS wear gloves when

changing bits. Accessible metal parts on the tool and

bits may get extremely hot during operation. Small

bits of broken material may damage barehands.



WARNING: Do not attempt to tighten or loosen drill

bits (or any other accessory) by gripping the front part

of the chuck and turning the tool on. Damage to the

chuck and personal injury mayoccur.

1. Insert the bit shank into the tool holder

13

as far as

it will go. The groove on the chisel shank

 must

be aligned with the symbol

 on the toolholder. If

inserted correctly, the locking sleeve

16

moves back to

the end position and shows a closed locksymbol.

2. Pull on the bit to be sure that it is properlylocked.

3. If the chisel groove is not aligned with the symbol, or

is not inserted to the complete depth the lock symbol

remainsopen.

4. To remove the bit, pull back the locking sleeve and pull

the bitout.

Fig. C

Inserting and Removing SDS Max

Accessories (Fig. D)

D25604, D25831

1. Pull back the locking sleeve

16

and insert the bit shank.

The bit shank must beclean.

2. Turn the bit slightly until the sleeve snaps back

intoposition.

3. Ensure the bit is properlyengaged.

nOTE: The bit needs to move several centimeters in and

out of the tool holder

13

when properlyengaged.

4. To remove the bit, pull back the locking sleeve and pull

the bitout.

Fig. D

13 16

E-Clutch® System (Fig. E)

D25604, D25652

In addition to the clutch, the

DeWALT

an anti-rotation

system, E-Clutch®, offers increased user comfort through

an on-board, anti-rotation technology capable of detecting

if the user loses control of the hammer. When a jam is

detected, the torque and speed are stopped instantly. This

feature prevents self-rotation of the tool. The red indicator

LED

illuminates when the E-Clutch® System is engaged.

Fig. E

Loading ...

Dewalt D25604K 1-3/4 in. SDS MAX Combination Hammer

Instruction Manual - Page 7