Loading ...
Loading ...
Loading ...
en Troubleshooting
44
Fault Cause and troubleshooting
"E:35 / -10" ▶ Turn off the water tap.
▶ Call the after-sales service.
→"Customer Service", Page52
lights up. The temperature is too high.
▶ Wait until the temperature has dropped.
▶
→"Cancelling the programme", Page34
Water level is too high.
▶ Select a suitable programme for draining.
→"Programmes", Page28
flashes. Door is not closed.
▶ Close the door.
Laundry is caught in the door.
▶ Remove any trapped laundry.
While the programme
is running, no status
display is shown on
the display.
This is not a washing programme, so a status display
is not provided.
▶ Not a fault – no action required.
"E:30/-20" Detergent dosage is too high.
▶ Reduce the amount of detergent for the next wash-
ing cycle with the same load.
Additional water is added.
▶ Do not add any extra water to the appliance while it
is operating.
Solenoid valve defective.
▶ Call the after-sales service.
→"Customer Service", Page52
All other error codes. Malfunction
1. Switch the appliance off and then on again.
2. If the message appears again, disconnect the appli-
ance from the power supply for at least 30 seconds
by pulling out the plug or by switching off the relev-
ant circuit breaker in the fuse box.
a If the fault was a one-off, the message disappears.
3. If the message appears again, call the after-sales
service. Please specify the exact error message
when calling.
→"Customer Service", Page52
The appliance is not
working.
The mains plug of the power cord is not plugged in.
▶ Connect the appliance to the power supply.
The circuit breaker in the fuse box has tripped.
Loading ...
Loading ...
Loading ...