Loading ...
Loading ...
Loading ...
sharkclean.comsharkclean.com
MAINTENANCE
EMPTYING THE DUST BIN
With the fluid reservoir removed, press the Dust Bin
Release Button and slide out the dust bin.
To open the dust bin lid, press and hold the button
while lifting the lid, using the finger slots.
Empty debris and dust into trash. Wash dust bin if
necessary, using water only.
NOTE: Make sure to insert the dust bin completely, until
it clicks into place.
To avoid mold, clean the area between the filter
and the plastic shield after every mopping run, and
periodically after vacuuming. Remove the shield
and clear any debris buildup with a dry cloth or
soft brush.
MAINTENANCE
CLEANING AND REPLACING THE FILTER
Remove and empty the dust bin. Clean any hair or
debris o the Anti-Tangle Comb on the back of
the dust bin.
Pull filter out of the dust bin by the tabs.
Lightly tap the filter to remove debris every time
you empty the dust bin. For a deeper clean, rinse
the filter with water once a month. Allow the filter
to air-dry for up to 24 hours before reinstalling. Do
not use soap or scrub the filter. This will damage
the material.
Reinsert the filter into the dust bin, then slide the
dust bin back into the robot until it clicks into
place.
For optimal suction power, after each use, clean and reinsert the filter inside the robot's dust bin.
See sharkaccessories.com for replacement filters.
NOTE: Replace the filter once a year for optimal performance.
Loading ...
Loading ...
Loading ...