Tripp Lite SMART1500RT1U Owner's Manual

Loading ...

4 Connections

4.4 Utility Power Connection

1. Before connection, read section 4.1 Pre-Connection Warnings.

2 Use the provided input cable to connect the UPS and a wall outlet that has an earthing-contact function. If the wall outlet

does not have an earthing connection, please ground the UPS via the ground terminal. Refer to section 2.3 Rear Panels

for ground terminal location.

3 After the UPS is connected to the AC utility, the utility will supply power to the UPS. Once power is supplied, the fan (at the

rear panel) will run and the LEDs and LCD will illuminate for 2-3 seconds. The user can check whether the LEDs and LCD

are normal. The default setting of the UPS will be set to standby mode.

Initial Screen after Utility Power Connection/Standby Mode

Notes:

• The above screenshot is for reference only. What is actually displayed depends on the operation of the UPS.

• The UPS will charge its internal batteries whenever the UPS is connected to the AC source.

• It is recommended that you charge the UPS internal batteries until the Battery Level Bar Graph shown on the UPS LCD appears full.

If the UPS batteries are not fully charged, you may still use the UPS immediately, but the On-Battery runtime may be less than normally

expected.

• If the UPS is going to be out of service or stored for a prolonged period of time, you must fully recharge the batteries every three months

so that the Battery Level Bar Graph shown on the UPS LCD appears full.

• The batteries will immediately begin charging upon the availability of the input power.

Loading ...

Tripp Lite SMART1500RT1U 1440VA 1100W 120V Line-Interactive UPS - 5 NEMA 5-15R Outlets, Network Card Option, USB, DB9, 1U Rack/Tower