Loading ...
Loading ...
Loading ...
• Inatailnewhettery withterminaisin
seine positionasoldbattery.
• FirstconnectRED batterycabletoposi-
tive (+)terminalwithhexboltand keps
nutas shown."nghtansecurely.
• ConnectBLACKgroundingcableto
negative(-) terminalwithremaininghe:<
beltand kepsnut."13ghtansecurely.
• Closebatterybox door.
Hex Bolt
TO REMOVE HOOD AND GRILL
ASSEMBLY
• Raisehood.
• Unsnapheadlightwireconnector.
• Standinfrontoftmutor.Grasphoodat
sides,tilttowardengineand liftoffof
tmctor.
• To replace,reverseaboveprocedures.
Headlight
r
Positive (Red) Cable Negative (Black) Cable
TO REPLACE HEADLIGHT BULB
• Raise hood.
• Pull bulb holder out of the hole in the
backside of the grill.
• Replace bulb in holder and push bulb
holder securely back intothe hole in the
backside ofthe gdll.
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged widng may cause your
tractor to run poorly, stop running, or pre-
vent it from starting.
• _Checkwiring. See electrical wldng dia-
gram in the Repair Parts section of this
manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
ENGINE
Maintenance, repair, or replacement of the
emission control devicse and systems,
which are being done at the customers
expense, may be performed by any non-
road engine repair ostablishement or indi-
vidual. Warranty repairs must be per-
formed by an authorized engine manufac-
turer's service outleL
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at the
factory and adjustment should not be nec-
essary. Check adjustment as deecdbed
below before loosening cable. Ifadjust-
ment is necessary, proceed as follows:
• With engine not running, move throttle
control lever from slow to choke posi-
tion. Slowly move lever from choke to
fast position.
• Check that holes "A• in govemor control
lever and hole in governor plate line-up.
If holes "A"am not aligned, loosen
clamp screw and move throttle cable
until holes are aligned. Tighten clamp
screw S(_'U roly,
25
Loading ...
Loading ...
Loading ...