Loading ...
Loading ...
Loading ...
38730-0-0318
GAS REQUIREMENTS
GAS SAFETY INSTRUCTIONS
Your gas Appliance is designed for use with
natural gas (NG) or LP gas. The gas
pressure regulator supplied with this
appliance must be installed and used on your
Gas Appliance. The
unit and Regulator are set to operate with an
outlet pressure of 4" W.C. for NAT gas. When
using LP gas, the regulator and Gas
Appliance orifices must be connected to LP
gas. (See converting your gas grills section).
Install a Shut-Off Valve at the gas supply
source outdoors at a point after the gas
pipe exits the outside wall and before the
flex-line or quick-disconnect hose. Or install
it at the point before the gas line piping
enters the ground.
Pipe sealing compound or pipe thread tape
resistant to the action of natural gas must be
used on all male pipe thread connections.
Disconnect your gas Gas Appliance from
fuel source when the gas supply is being
tested at high pressures.
This gas Gas Appliance and its individual
shutoff valve must be disconnected from the
gas supply pipe system during any pressure
testing of that system at pres-sure in excess
of 1/2 psi (3.5kpa). Turn off your gas Gas
Appliance when the gas supply is being
tested at low pressures. The Gas Appliance
must be isolated from the gas supply pipe
system by closing its individual manual
shutoff valve during any pres-sure testing of
the gas supply pipe system at pressures
equal to or less than 1/2 psi (3.5kpa).
1.
Make a soap solution by mixing one part
liquid detergent and one part water.
2.
Turn the Gas Appliance Control Knobs to
their full OFF positions. Next, turn the gas
ON at the source.
3.
Apply the soap solution to all gas
connections. If bubbles appear in the
soap solution the connections are not
properly sealed. Check each fitting and
tighten or repair as necessary.
Gas Requirements And Hook-up (Cont'd.)
PREMIUM GRILLS
Page 15
CHECK ALL CONNECTIONS
FOR GAS LEAKS
Never test for leaks with an open ame.
Prior to rst use and at the beginning
of each season, you must check for gas
leaks. Follow these three steps:
Loading ...
Loading ...
Loading ...