Loading ...
Loading ...
Loading ...
UsingRecordingTimer
With Recording Timer, you can make a tape of a radio
broadcast automatically. You can set the timer whether the
system is on or off',
HowRecordingTimer actuallyworks
The unit automatically turns on, tunes into dae specified
station, sets lhe volume level to "MIN," and starts recording
when the on-fime comes (the _ indicator flashes just before
the on-time, and conlinues flashing while the timer is
operating), Then, when the off-time comes ("OFF" appears
just before the oft-time), the unit automatically turns off (on
standby).
The timer setting remains in memory until you change it,
• There is a time limit in doing the following sleps, if the
setting is canceled before you finish, start from step 1
again.
• To correct a mis-entry while selting the timer, press
CANCEL/DEMO,
On the unit ONLY:
1Put a recordable cassette into deck B.
2 Press CLOCK/TIMER repeatedly
until "REC" appears on the
display.
The REC (Recording Timer) indicator also
starts flashing on the display.
P,E,'-_
• Each time you press the bulton, the timer setting modes
change as follows:
o,eo0-
setting
(See page 9)
3Press CLOCK/TIMER again.
"ON TIME" appears for 2 seconds then the
unit enters on-time setting mode,
4 Set the on-time you want the
unit to turn on at.
1) Turn 141_1/ _t to set the hour,
then press SET/DISPLAY,
2) Turn t_l_l / _ to set the minute,
then press SET/DISPLAY,
"OFF TIME" appears for 2
seconds, then the unit enters off'-
time setting mode.
5 Set the oil:time you want the
unit to turn off(on standby) at.
1) Turn 141_1/ _t to set the hour, then press
SET/DISPLAY,
2) Turn 141_1/ _t to set the mintue, then press
SET/DISPLAY,
The unit enters preset station selecting mode.
8_'/DIIDL4 y
6Select the preset station.
1) Turn 1414/ _ to select the band ("TUNER FM" or
"TUNER AM"), then press SET/DISPLAY.
2) Turn 141_1/ _ to select a preset channel number,
then press SET/DISPLAY,
The REC (Recording Timer) indicator stops flashing
and remains lit. The settings you have done are shown
on the display in sequence.
7 Press STANDBY/ON O/I to sT_By_o_
turn off the unit (on standby) O/_o_,--
if necessary.
\-
_lf you want to listen to another source while recording
Press REC START/STOP or • to stop recording. Without stopping
it, you cannot change the source.
Even if you unplug the AC power cord or if a power
failure occurs
Once you set the timer, the timer setting may remain stored in
memory in a few days. In this case, check whether the timer setting
still remains or not.
r-ltl
- 23 -
Loading ...
Loading ...
Loading ...