HET06-J-2H
The HET06-J-2H is a timer switch with 6 preset time buttons and 1 Manual
ON button. All Loads connect to this timer will automatically turn OFF when
the selected time expires. The 6 selectable times are 5 Min, 10 Mins, 20 Mins,
30 Mins, 1H, 2H.
© 2022 Enerlites Inc.
CA, U.S.A.
WWW.ENERLITES.COM
0204220195
This device is intended for installation in accordance with the National Electric
Code and local regulations.
Use Copper wires ONLY.
WIRING DIRECTIONS
Preset In-Wall Countdown Timer
Seven-button Preset Time Switch
Time Delay
5, 10, 20, 30 minutes, 1H, 2H
Replace a standard light or fan single pole switch
Work with most common lighting types
Ideal for closet, pantry, garage, laundry room, outdoor lighting and spa.
Resistive..................................................................................800W-125VAC, 60Hz
Tungsten..................................................................................800W-125VAC, 60Hz
Fluorescent.............................................................................800VA-120VAC, 60Hz
Electronic Ballast....................................................................800VA-125VAC, 60Hz
Motor......................................................................................1/4 HP-125VAC, 60Hz
Time Delay...................................................................5, 10, 20, 30 minutes, 1H, 2H
Humidity.............................................................................95% RH, non-condensing
Operation Temperature.........................................................................32° F--131° F
Read and understand these instructions before installing. It is recommended that
a qualified electrician performs this installation. Make sure to turn off the circuit
breaker or fuse(s) and make sure power is off before wiring the device.
“Caution: High Voltage-Disconnect power supply before servicing”
Turn the power off at the circuit breaker before installing
the Timer.
1. Connect the BLACK wire on the switch to the HOT wire.
2. Connect the RED wire on the switch to the LOAD wire.
3. Connect the GREEN wire on the switch to the GROUND wire.
Preset Buttons: The LED indicator will blink twice to confirm each button press.
There are 6 buttons with preset times of
5 Min, 10 Mins, 20 Mins, 30 Mins, 1H, 2H
.
desired time once to
turn the Load on for that selected amount of time.
o When the time expires, the Load will automatically turn off.
esired time once to
restart the countdown with the newly selected time.
Manual ON Button: The LED indicator will blink twice to confirm each button press.
The Manual ON button is the large button located below the preset buttons.
to turn the Load
ON with the last selected timer preset.
to override the timer
and turn the Load OFF.
8 seconds. The
Load will turn ON and stay ON. The timer WILL NOT turn the Load OFF.
o Press and release the Manual ON button to turn the Load OFF.
o Press and release the button with the desired time once to keep the Load
on for that selected amount of time.
LED Light: the LED indicator light next to each selected button blinks twice each
time it is pressed to mark the time selected.
SETTING/ OPERATING
WARRANTY INFORMATION
FEATURES
DESCRIPTION
SPECIFICATIONS
WARNING
Manual ON
Button
Preset Timer
Buttons
LED
Indicators
1 Hour 2 Hour
20 Min 30 Min
5 Min 10 Min
1 Hour 2 Hour
20 Min 30 Min
5 Min 10 Min
This device is warranted to be free of material and workmanship defects for 2 years from the date of
purchase. Original receipt or proof of purchase from an authorized retailer must be presented upon warranty
claim. ALL claims must be verified and approved by Enerlites, Inc. Warranties from other Enerlites products
may vary. This warranty is nontransferable and does not cover normal wear and tear or any malfunction,
failure, or defect resulting from misuse, abuse, neglect, alteration, modification, or improper installation. To
the fullest extent permitted by the applicable state law, Enerlites shall not be liable to the purchaser or end
user customer of Enerlites products for direct, indirect, incidental, or consequential damages even if Enerlites
has been advised of the possibility of such damages. Enerlites’ total liability under this or any other warranty,
express or implied, is limited to repair, replacement or refund. Repair, replacement or refund are the sole and
exclusive remedies for breach of warranty or any other legal theory.
1 Hour 2 Hour
20 Min 30 Min
5 Min 10 Min
