Loading ...
Loading ...
Loading ...
11
Troubleshooting
Problem Possible Solution
The appliance does
not work after the
switch is turned on
Ensure that the plug is properly connected.
Check that the power cord is not damaged.
The overheat protection has activated. Refer to the Safety Cut-off section.
When the water spray
button is pressed,
there is no or little
water.
Ensure that the nozzle is not blocked. Remove and rinse with clean
water.
Check that the handle or pump is not damaged.
The suction does not
work or is very weak.
Ensure that the power switch is turned on.
Ensure that the dirty water tank is correctly installed.
Empty the dirty water tank. If this tank is full, the floating ball may have
activated in the tank.
Ensure that he hose is not twisted, damaged or blocked.
Ensure that the inlet air sponge is not clogged. Clean or replace the
sponge.
Cleaning & Care
WARNING! Always switch off the appliance and unplug from the mains socket before carrying out
and cleaning and care.
DO NOT use chemical cleaners or abrasives to clean the appliance.
DO NOT immerse the appliance, cord or plugs in water or any other liquid.
Cleaning the Dirty Water Tank:
Note: This unit is equipped with an overflow protection feature, which will filter water out of the
front of the appliance whenever the dirty water tank is left full. This helps protect the electronics
inside the appliance from accidental water damage when the tank is left full.
1. Empty the dirty water tank when full or when cleaning is complete, in order to prevent
bacteria and bad odours.
2. Remove the dirty water tank taking care not to shake and tip the tank in order to prevent
leakage.
3. Open the upper cover of the dirty water tank, lifting the locking tab, and pour away the
contents.
Loading ...
Loading ...
Loading ...