Loading ...
Loading ...
Loading ...
16
ICE AND WATER Possible Causes and/or Recommended Solutions
Water is leaking or dripping
from the dispenser NOTE: After dispensing, a few additional drops of water are normal.
■■Glass was not held under the dispenser long enough - Hold the glass under the dispenser
for 2 to 3 seconds after releasing the dispenser pad/lever.
■■New installation, or water filter was recently installed or replaced - Air in the water lines
causes the water dispenser to drip. Flush the water system to remove the air in the water
lines. See the “Water and Ice Dispensers” section.
■■Residual ice in the dispenser chute is melting - Make sure the ice chute is free of ice
shavings or pieces.
Water is leaking from the back
of the refrigerator
■■Water line connections are not fully tightened - Make sure all connections are rmly
tightened. See the “Connect Water Supply” section.
Water from the dispenser is
not cool enough (on some
models)
NOTE: Water from the dispenser is chilled to 50°F (10°C).
■■New installation - Allow 24 hours after installation for the water supply to cool completely.
■■Recently dispensed a large amount of water - Allow 24 hours for the new water supply to
cool completely.
■■Water has not been recently dispensed - The rst glass of water may not be cool. Discard
the rst glass of water dispensed.
■■Refrigerator is not connected to a cold water pipe - Make sure the refrigerator is
connected to a cold water pipe. See the “Water Supply Requirements” section.
Loading ...
Loading ...
Loading ...