Loading ...
Installation & wiring
Figure 2
Using an Octagonal J-Box
7. Snap the front cover onto the sensor.
J-Box Mount
Front Cover
Rear Housing
Wire
Screws
Octagonal box
mounting
Drop Ceiling
1. Pull the low voltage wires from the power pack into the J-Box through the conduit knockout.
2. Connect the low voltage wires to the appropriate terminals on the sensor.
3. Loosen the appliance mounting screws attached to the J-Box.
4. Align the sensor in the J-Box so that the mounting screws on the box match the key holes on
the sensor
’s rear housing.
5. Push the sensor up into the J-Box and twist it so that the mounting screws are seated in
the keyhole slots.
6. Tighten the two screws to secure the sensor to the J-Box.
terminals
Wiring
Common
+24VDC
Manual ON
Passive Infrared Occupancy Sensor
+24VDC Connect to MPP-24 or other
Class 2 Power Packs
Model#:
For Indoor Use Only
MPC-50L
Control Out
Each MPP-24 power pack can supply power for 6 MPC-50L sensors. When using
more sensors than this, multiple power packs are required.
CAUTION!
TURN POWER OFF A
T THE CIRCUIT BREAKER BEFORE INSTALLING
POWER PACKS OR SENSORS.
Common
+24VDC
Manual ON
Control Out
Connect the low voltage:
RED wire (+24VDC) from power pack to the +24V terminal on the sensor.
BLACK wire (Common) from power pack to Common terminal on the sensor.
Wiring a SINGLE LIGHTING LOAD CONTROLLED BY OCCUP
ANCY - Connect:
BLUE wire from power pack to Control Out terminal on sensor.
Wiring multiple SINGLE LIGHTING LOADs CONTROLLED BY OCCUPANCY,
ON LIGHT LEVEL (AMBIENT LIGHT)
- Connect:
BLUE wire from power pack to Control Out terminal on sensors.
To add a MANUAL SWITCH such as the YQDS115M Momentary Toggle Switch,
applications - connect:
1. Wire from one side of switch to Common terminal on sensor.
2. Wire from other side of switch to Man Switch terminal on sensor.
DEPENDENT
to the above
Figure 1
Loading ...