Loading ...
Loading ...
Loading ...
14
Connect neutral wire (white or center wire) (C) of power supply
cord or cable under center terminal block screw (B). Tighten
screw.
Place ends of remaining wires under outer terminal block screws.
Tighten screws.
3-Wire Connection with External Ground
Connection (Power Supply Cord Shown)
IMPORTANT: You must verify with a qualified electrician that
this grounding method is acceptable before connecting. If a
3-wire connection necessary, an external ground wire must be
connected per the following instructions.
2. Connect neutral wire
1. Prepare to connect neutral wire
3. Connect remaining wires
Install the correct strain relief for your electrical connection
method, as shown on page 13.
Remove center terminal block screw (B). Remove green external
ground conductor screw (A).
Connect a separate copper ground wire (G) under the green
external ground conductor screw (A) to an adequate ground.
Finally, reinsert tab of terminal block cover into slot of dryer rear
panel. Secure cover with hold-down screw. Now go to “Venting
Requirements.”
4. Connect external ground wire
4. Connect remaining wires
Place hooked ends of remaining direct wire cable wires under
outer terminal block screws (hooks facing right). Squeeze
hooked ends together and tighten screws. Finally, reinsert tab of
terminal block cover into slot of dryer rear panel. Secure
cover
with hold-down screw. Now go to
“Venting Requirements.”
Loading ...
Loading ...
Loading ...