Zibro LC 300 User Manual

Loading ...

H: The TIMER indicator

light indicates that the

timer function has been

switched on.

E SETTING THE REQUIRED TEMPERATURE

The฀temperature฀setting฀can฀only฀be฀adjusted,฀when฀the฀heater฀is฀burning.฀Use฀

the adjustment keys N฀to฀adjust฀the฀temperature.฀First฀press฀either฀of฀the฀two฀

keys to switch on the function (the °C mark K will start blinking). Next, adjust the

temperature using the key on the right (Mmin.) to set the temperature to a higher

setting and the key on the left (Nhour)฀to฀lower฀the฀temperature.฀Press฀once฀to฀

increase฀the฀value฀one฀step.฀After฀approximately฀10฀seconds฀the฀°C฀mark฀will฀stop฀

blinking฀and฀the฀setting฀will฀be฀locked฀(Fig.฀G).

The฀available฀temperature฀settings฀range฀from฀6°C฀minimum฀to฀28°C฀maximum.฀

When the heater has been unplugged (or after a power failure), the temperature

will reset to the factory setting of 20°C.

F USING THE TIMER

The timer allows you to switch on the heater automatically at a preset time.

In order to switch on the timer, the correct time must have been set

(refer to

Section C)

฀and฀the฀heater฀should฀be฀off.฀Follow฀the฀procedure฀below:

Press฀the

button L and then the TIMER key O immediately after that.

The TIMER lamp ฀and฀the฀4-digit฀K will start blinking.

Use฀the฀adjustment฀keys฀N to set the time at which the heater must ignite.

฀Use฀the฀key฀on฀the฀left฀(Nhour) to set the hours and the key on the right

(Mmin.) to set the minutes (interval of 5 minutes)

After฀approximately฀10฀seconds฀the฀4-digit฀will฀show฀CLOCK฀again฀and฀the฀

TIMER lamp  will light up, indicating that the timer function has been

฀activated฀(Fig.฀H).

The timer will ensure that the room will have been heated to approximately

฀the฀required฀temperature฀at฀the฀set฀time.

When you want to switch off the heater and ignite it again with the timer, all

you have to do is press the TIMER key

(refer to Section G).

Press฀the฀

button L once to clear the timer setting.

G SWITCHING OFF THE HEATER

There are two ways to switch off the heater:

Press฀the฀

button L. The information display will show the CLOCK

signal. Within approximately one minute the flame will have extinguished.

Press฀the฀TIMER฀key฀O, when you want to switch off the heater and ignite it

again with the timer the next time. This not only switches off the heater, but

฀it฀also฀activates฀the฀timer฀function.฀You฀can฀change฀the฀required฀time฀with฀

the adjustment keys N

(refer to Section F).

Loading ...

Zibro LC 300

User Manual - Page 9