Loading ...
Loading ...
Loading ...
NOTE
Be aware that a rest of dust and debris can fall out the filter
when pulling too quickly.
6. Turn the strainer (26) counter-clockwise and remove it.
7. Shake the filter and empty the debris into a waste bin.
8. Run water through the filter from a hose or spigot.
9. Allow the filter to completely dry before storing or
picking up debris.
WARNING
Do not operate the machine without collection bin or filter.
9.2 CLEAN THE BRUSH ROLL
Figure 12
WARNING
Turn off the machine before maintenance or troubleshooting
to reduce the risk of electric shock or injury.
1. Press the release button (8) to disconnect the motorized
brush head (4) from the vacuum.
2. Push the brush roll release button (27) so the side plate
(28) will release.
3. Lift the side plate (28).
4. Take the brush roll (29) out.
5. Clean up the debris and hairs.
6. Run water through the brush roll from a hose or spigot.
7. If your brush roll chamber is dirty, use the rag or towel to
clean it.
8. Allow the brush roll and chamber to completely dry
before storing or picking up debris.
9.3 CLEAN THE PIPE
Figure 13
NOTE
Turn off the machine before maintenance or troubleshooting
to reduce the risk of electric shock or injury.
1. Press the release button toremove the extension pole and
floor brush.
2. Empty the collection bin.
3. Remove the brush roll.
4. Check the pipes of the vac, brush and extension pole.
5. Pump the debris out or use the wire to clean the pipes if
pipes are blocked.
10 TROUBLESHOOTING
Problem Possible cause Solution
The machine
doesn't work.
The switch or mo-
tor is defective.
Speak to service
center.
The battery is not
inserted correctly.
Follow the manual
to reinstall the bat-
tery.
The battery is out
of power.
Charge your bat-
tery.
Dust discharges
from machine.
The filter has dam-
age.
Replace the filter.
The filter isn't in-
stalled.
Properly reinstall
the filter.
The filter is not
functional.
Clean or replace
the filter.
The filter clogs.
Clean or replace
the filter.
Loss of suction
The filter clogs.
Clean or replace
the filter.
The collection bin
is full.
Empty the collec-
tion bin.
Errors
Problem Possible cause Solution
Only one red LED
light is on and
flashes then ma-
chine shutdown
automatically.
Battery is dead. Place the machine
on charging sta-
tion.
The wand debris
light (19) is on,
LED lights turn to
red and the ma-
chine shutdown
automatically.
Clear wand debris.
1. Remove the
battery pack.
2. Remove the
extension pole
from the vac-
uum.
3. Pump the deb-
ris out.
4. Call service
center if it still
doesn't work.
8
English
EN
Loading ...
Loading ...
Loading ...