Loading ...
Loading ...
Loading ...
21
STORAGE & TRANSPORT PROCEDURES
STORAGE
WARNING: Gasoline is highly flammable and extremely explosive. Empty the fuel tank
and shut off fuel valve before storing or transporting this generating set.
The generating set should be started at least once every 2 weeks and allowed to run for at
least 20 minutes. Follow the instructions below for longer term storage if the generating set will be
out of service for 2 months or more.
Allow the generating set to cool completely before storage.
Clean the generating set according to instruction in maintenance section.
Drain all fuel completely from the fuel tank, fuel hose and carburetor to prevent gum from forming.
Turn off the fuel supply at the fuel valve.
Change the oil.
Reattach the spark plug.
Remove the spark plug and pour about 15ml of oil into the cylinder.Crank the engine slowly
to distribute the oil and lubricate the cylinder.
Store the unit in a clean, dry area out of direct sunlight.
TRANSPORT
To prevent fuel spillage when transporting or during temporary storage, the generating set should be
secured upright in its normal operating position, with the engine switch OFF. The combination switch
should be in the “stop” position and knob of the fuel cap should be turned to the “OFF” position.
When transporting:
Do not overfill the tank.
Do not operate the generating set while it is on vehicle. Take the generating set off the vehicle and
use it in a well-ventilated place. Avoid a place exposed to direct sunlight when putting the generating set
on a vehicle. If the generating set is left in an enclosed vehicle for many hours, high temperature inside
the vehicle could cause fuel to vaporize resulting in a possible explosion.
Do not drive on a rough road for an extended period with the generating set on a rough road, drain the
fuel from the generating set beforehand.
Loading ...
Loading ...
Loading ...