Loading ...
Loading ...
Loading ...
9. Apply a small amount of grease to the axle on the left
Crank Arm (6).
Side a Plastic Pedal Spacer (92) and the Left Pedal
Arm (3) onto the axle on the left Crank Arm (6). Note: It
may be helpful to use a rubber mallet to tap these parts
on. Be careful not to confuse the Left Pedal Arm
with the Right Pedal Arm (not shown); look at the
position of the round tube to identify the Left Pedal
Arm. Next, tap a 3/4" Axle Cap (61) onto the axle.
Attach the Right Pedal Arm (not shown) in the same way.
10.Apply grease to the welded bolt on the Left Pedal Arm
(3). Slide a Chrome Tube (21) and a Chrome Tube
Washer (84) onto the welded bolt. Make sure that the
Chrome Tube is turned exactly as shown in the
inset drawing. Then, tighten an M1O Nylon Locknut
(26) onto the welded bolt.
Attach the other Chrome Tube (not shown) to the Right
Pedal Arm (4) in the same way.
Apply a small amount of the included Teflon'_lubricant
to a paper towel. Rub a thin film of the lubricant onto
both Chrome Tubes (21).
11.Slide the Left Upper Body Arm (7), which is marked
with an "L" sticker, onto the Chrome Tube (21) on the
Left Pedal Arm (3). Slide the Right Upper Body Arm
(75) onto the Chrome Tube on the Right Pedal Arm (4).
Make sure that the Upper Body Arms are on the
correct sides--the upper ends should bend in the
direction shown by the arrows. Next, slide an Axle
Cover (74) onto the post on each Upper Body Arm.
Apply grease to the Arm Axle (19). Insert the Arm Axle
into the Right Upper BodyArm (75) and the right Pivot
Cover (74). Next, insert the Arm Axle into the Upright
(2) until the left end of the Axle is flush with the left side
of the Upright. Then, insert the Arm Axle into the left
Axle Cover (74) and the Left Upper Body Arm (7).
Center the Arm Axle.
Using the included pedal tool, tap two Push Nuts (15)
about 1/8" onto each end of the Arm Axle (19). Make
sure that the Push Nuts are turned as shown in the
inset drawing. Note: It may be helpful if another person
holds a block of wood against one end of the Arm Axle
while you tap Push Nuts onto the other end.
Press an Axle Cap (34) onto each end of the Arm Axle
(19).
10
26 Welded Bolt
11
Post
Pedal Tool 15 19
Tube
Wide
Side
1
9[
26 84
Narrow
Side
15
12. Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware
may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat
under the elliptical crosstrainer.
8
Loading ...
Loading ...
Loading ...