Loading ...
bromic.com
IMPORTANT
Head Oce: 10 Phiney Place, Ingleburn, NSW 2565 Australia
Telephone: 1300 276 642 (within Australia) or +61 2 9748 3900 (from overseas) Fax: +61 2 9748 4289
Email: [email protected] Web: www.bromic.com
Note: Bromic Pty Ltd reserves the right to make changes to specications, parts, components and equipment without
prior notication. This installation, operation and service manual may not be reproduced in any form without prior
written consent from Bromic Pty Ltd.
This manual contains important information about the installation, and
operation of Bromic Smart-Heat
TM
Link. Please pay close attention to the important
safety information shown throughout this instruction manual. Any safety information
will be accompanied by the following safety alert symbols:
• READ THIS MANUAL CAREFULLY before installing or servicing
this product.
• Use this device only as described in this manual. Any other
use not recommended by the manufacturer may cause radio
interference, re, electric shock, or injury to persons
• This controller is intended for installation with a DC power supply.
• Installation MUST be carried out by a licensed and authorised
technician in accordance with local electrical codes.
• For Commercial Use Only
DANGER WARNING IMPORTANT
NOTE: IMPORTANT INSTRUCTIONS, SAVE THESE INSTRUCTIONS
!
!
!
• The inputs are NOT protected against short circuits which can damage the
electronic board.
• The radio signal reception of the device can be aected by the presence of electrical
disturbances being transmitted by other appliances working on the same frequency or if
the product is shielded by metal parts.
• Do not use the device in places where systems are sensitive to radio emissions.
• Do not keep or use the device in places that are damp, where there is steam, high air
humidity, dust or where it is exposed to direct sunlight or similar environmental conditions.
• Do not drop the device. This could damage or reduce the range of transmission.
• Keep device out of reach of children.
!
WARNING
Loading ...
Loading ...
Loading ...