Loading ...
Loading ...
Loading ...
Freshautomatic
dishwasherdetergent
resultsinbetter
cleaning.Storetightly
closeddetergent
containerinacool,dry
place.
A. Cover la tch
B. Main Wash section
C. Pre-Wash section
• The amount of detergent to use depends on:
How much soil remains on the items -- Heavily soiled loads
require more detergent.
The hardness of the water -- If you use too little in hard water,
dishes won't be clean. If you use too much in soft water,
glassware will etch.
Soft to Medium Water (0-6 grains per U.S. gallon)
[typical water softener water and some city water]
Medium to Hard Water (7-12 grains per U.S. gallon)
[well water and some city water]
• Depending on your water hardness, fill the Main Wash section
of the dispenser as shown. Fill the Pre-Wash section to the
level shown, if needed.
NOTE: Fill amounts shown
are for standard powdered
detergent. Follow
instructions on the package
when using other dishwasher
detergent.
HardWater
Soft Water
Main Wash
HardWater
SaltWater
Pra-Wash
Add Rinse Aid
Your dishwasher is designed to use rinse aid for good drying
performance. Without rinse aid your dishes and dishwasher
interior will have excessive moisture. The heat dry option will
not perform as well without rinse aid.
Rinse aid keeps water from forming droplets that can
dry as spots or streaks. They also improve drying by
allowing water to drain off of the dishes after the final
rinse.
Rinse aid helps to reduce excess moisture on the dish
racks and interior of your dishwasher.
C
Full
Add
Check the rinse aid indicator. Add rinse aid when indicator
drops to "Add" level.
To add rinse aid, turn the dispenser cap
to "Refill" and lift off. Pour rinse aid into
the opening until the indicator level is at
"Full." Replace the dispenser cap and
turn to "Lock." Make sure cap is fully
locked.
Lock
Refill__
turn to lock
NOTE: For most water conditions, the
factory setting of 2 will give good
results. Ifyou have hard water or notice
rings or spots, try a higher setting. Turn
the arrow adjuster inside the dispenser
by either using your fingers or inserting
a flat-blade screwdriver into the center
of the arrow and turning.
STEP 3
Select a Cycle (cycles vary by model)
See "Cycle and Option Descriptions" charts in the following
section.
Heavier cycles and options affect cycle length. Some cycles and
options will take up to 31/2hours to complete.
RINSE
HEAVY NORMAL CHINA ONLY
@(_@(_@(_@(_ CYCLES
Select Options (options vary by model)
See "Cycle and Option Descriptions" charts in the following
section.
You can customize your cycles by pressing the options desired.
HI-TEMP HEAT 4 HOUR
WASH SANITIZE DRY DELAY
OPTIONS@(_0(_@(_@(_
STEP4
Start or Resume a Cycle
• Run hot water at the sink nearest your dishwasher until the
water is hot. Turn off water.
Push door firmly closed. The door latches START/
automatically. Select the wash cycle and options RESUME
desired OR press START/RESUME to repeat the
same cycle and options as in the previous wash _@
cycle.
You can add an item anytime before the main wash starts.
Open the door slowly and add the item. Close the door firmly.
Press START/RESUME.
Loading ...
Loading ...
Loading ...