Loading ...
Loading ...
Loading ...
page 4
set screw hole
set screw
hanging ball
stop pin
A
B
pin
clip
NOTE: The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common
sense and caution are necessary factors in the
installation and operation of this fan.
5. Fan Assembly.
If you wish to extend the hanging length of
your fan, you must remove the hanging ball
from the downrod provided to use with an
extended downrod (sold separately). [If you wish
to use the downrod provided, please proceed to
instructions following the dotted line below.]
Loosen set screw on hanging ball and remove
pin and clip. Lower hanging ball and remove
stop pin. Slide hanging ball off the original
downrod, A, and slide it down the longer
downrod, B (the top of the downrod should be
noted as having a set screw hole; use this hole
when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging
ball. Be sure stop pin aligns with slots on the
inside of the hanging ball. Tighten set screw
securely.
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod.
Loosen yoke set screws and nut at top of motor
housing. Remove pin and clip from downrod (if
you have not already done so). Slide downrod
through canopy and yoke cover.
Thread electrical wires through downrod and
pull extra wire slack from the upper end of the
downrod.
Place downrod into the motor housing yoke
and re-insert pin and clip previously removed.
Tighten yoke set screws and nut securely. Lower
yoke cover to motor housing.
WARNING: Failure to tighten set screw
completely could result in the fan becoming
loose and possibly falling.
["Fan Assembly" continued on next page.]
motor
housing
yoke set screw
downrod
electrical wiring
clip
pin
canopy
yoke cover
Loading ...
Loading ...
Loading ...