Loading ...
Loading ...
Loading ...
12V DC Charging (60W).
The GB500 must be in 12V mode to be charged. Ensure the voltage selection knob is in the 12V position prior to charging. Connect the 12V Cable to the 12V IN
port on the GB500, and the other end to the Male 12V Plug. Plug into a powered 12V AUX Plug (Cigarette Lighter Port).
AC Charging (56W).
The GB500 must be in 12V mode to be charged. Ensure the voltage selection knob is in the 12V position prior to charging. Connect the XGC 12V Cable to the
12V IN port on the GB500, and the other end of the 56W Power Adapter to AC power (100-240VAC Wall Outlet).
Powering Your 12V Devices.
The GB500 must be in 12V mode to enable 12V OUT. Connect the 12V Cable to the 12V OUT port on the GB500, and the other end to the Female 12V Plug (12V
AUX / Cigarette Lighter Port). Plug-in any standard 12V device (up to 15A) with a 12V plug and turn the GB500 “On” to start powering your device.
Step 2: Connect to the Battery.
Carefully read and understand the vehicle owner’s manual on specific precautions and recommended methods for jump starting the vehicle. Make sure to
determine the voltage and chemistry of the battery system by referring to your vehicle’s owner’s manual prior to using this product. The GB500 is for jump
starting 12-volt and 24-volt lead-acid battery systems only. Before connecting to the battery, verify the battery system voltage. Ensure the voltage selection
knob is in the correct position (12V or 24V) matching the battery system being jump started. Never change the voltage while the unit is connected to a battery.
Only change the voltage while the unit is o. The GB500 is not suitable for any other type of battery systems. Identify the correct polarity of the battery terminals
on the battery. The positive battery terminal is typically marked by these letters or symbol (POS,P,+). The negative battery terminal is typically marked by these
letters or symbol (NEG,N,-). Do not make any connections to the carburetor, fuel lines, or thin, sheet metal parts. The instructions bellow are for a negative
ground system (most common). If your vehicle is a positive ground system (very uncommon), follow the instructions bellow in reverse order.
1.) Securely connect the negative (black) Boost Max Connector to the negative port on the GB500.
2.) Securely connect the positive (red) Boost Max Connector to the positive port on the GB500.
3.) Always clean terminals prior to connecting the clamps. NOTE: Faulty connections or dirty terminals may cause smoke. Batteries with very low voltage will
also increase the chance of smoke.
4.) Connect the positive (red) Boost Max Connector the positive (POS,P,+) battery terminal.
5.) Connect the negative (black) Boost Max Connector to the negative (NEG,N,-) battery terminal or vehicle chassis. Ensure both clamps have a secure
connection. (Grounding to the chassis may not be suitable for jump starting large applications.)
6.) When disconnecting, disconnect in the reverse sequence, removing the negative first (or positive first for positive ground systems).
EN
Loading ...
Loading ...
Loading ...