Loading ...
Loading ...
EN
W415-2016 / 07.12.22
3
table of contents
congratulations! 4
1.0 getting to know your appliance 5
1.1 control access 6
1.2 rating plate information 6
2.0 operating your appliance 7
2.1 on/off components 7
2.2 using your appliance 7
3.0 operation 8
3.1 pilot on demand 9
3.1.1 changing the batteries in the battery holder 10
3.1.2 turndown 11
4.0 remote control layout 12
4.1 general transmitter layout 12
4.2 temperature display 12
4.3 in the event of a battery failure 13
4.4 eFIRE Controller application 13
4.5 low battery 13
5.0 clearances around appliance 14
5.1 optional heat management system 15
6.0 maintenance 17
6.1 care of glass 17
6.2 care of plated parts 18
6.3 safety barrier removal/installation 18
6.4 firebox glass door removal 19
6.5 top and bottom door trim installation 19
7.0 replacement parts 20
8.0 accessories 21
9.0 troubleshooting 22
10.0 warranty 23
Changes, other than editorial, are denoted by a vertical line in the margin.
Before reading this manual, be sure you know which model of appliance that you have. This information will have
been filled out by the installer on the following page and on the rating plate that is permanently attached to the ap-
pliance (see “rating plate information” section).
This manual is for the:
• Altitude™ Series (A36 and A42 models)
If required, more detailed technical information is included in the appliance installation manual.
The information throughout this manual is believed to be correct at the time of printing. Wolf Steel Ltd. reserves
the right to change or modify any information within this manual at any time without notice.
Visit the Napoleon website for the most current version of your appliance’s manual.
Batteries must be disposed of according to the local laws and regulations. Some batteries may be
recycled, and may be accepted for disposal at your local recycling center. Check with your
municipality for recycling instructions.
This appliance is suitable for use with the Universal Heat Management system. THIS MANUAL DOES NOT
include detailed information relating the optional system. Framing and finishing are NOT the same. For further
details, refer to UHM instructions provided with the kit before starting installation.
Loading ...
Loading ...
Loading ...