Loading ...
Loading ...
Loading ...
Clearing a Jammed Fastener (Fig. 1, 7)
If a fastener becomes jammed in the nosepiece, keep the tool pointed away from you
and follow these instructions to clear:
1. Disconnect the tool from the air supply.
2. Release the pusher (G) so it is no longer applying force to the nail sticks.
3. Open the jam clearing nose door by pulling down and then up on the latch.
4. Remove the jammed fastener. In certain circumstances, pliers may be required to
remove the fastener.
5. Close the jam clearing nose door latch.
6. Pull nail pusher back behind nail sticks.
7. Perform tool operation check.
NOTE: Should fasteners continue to jam frequently in nosepiece, have tool serviced
by an authorized D
eWALT service center.
FIG. 7
Daily Maintenance Chart
ACTION
Drain compressor tanks and hoses daily
WHY
Prevents accumulation of moisture in compressor and nailer
HOW
Open petcocks or other drain valves on compressor tanks. Allow
any accumulated water to drain from hoses
ACTION
Clean magazine, pusher, and contact trip mechanism
WHY
Permits smooth operation, reduces wear, and prevents jams
HOW
Blow clean with compressed air. The use of oils or solvents is not
recommended as they tend to attract debris
ACTION
Before each use, check to ensure all screws, nuts and fasteners are
tight and undamaged
WHY
Prevents jams, leaks and premature failure of tool parts
HOW
Tighten loose screws or other fasteners using the appropriate hex
wrench or screwdriver
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air at least
once a week. To minimize the risk of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.
WARNING: Never use solvents or other harsh chemicals for cleaning the non-
metallic parts of the tool. These chemicals may weaken the plastic materials used in
these parts. Use a cloth dampened only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool into a liquid.
Lubrication
CAUTION: NEVER spray or in any other
way apply lubricants or cleaning solvents inside the
tool. This can seriously affect the life and performance
of the tool.
D
eWALT tools are properly lubricated at the factory
and are ready for use. However, it is recommended
that, once a year, you take or send the tool to a certified
service center for a thorough cleaning and inspection.
Repairs
WARNING: To reduce the risk of serious personal injury, remove nails from
magazine before making any adjustments or servicing this tool.
English
10
Loading ...
Loading ...
Loading ...