Loading ...
Loading ...
Loading ...
Belt Hook (Fig. 1, 5)
The belt hook (J) can be changed to either side of the tool to accommodate left- or
right-handed users.
INSTALLING THE BELT HOOK
WARNING: Disconnect air line from tool and remove fasteners from magazine
before making adjustments or before axttempting any assembly or disassembly.
WARNING: Always remove the belt hook from the tool when selecting Contact
Trip Mode.
1. Assure that the sequential trip mode is selected
2. Align belt hook with slot in bracket.
3. Slide belt hook into bracket slot.
4. Slide until belt hook snaps into place.
FIG. 5
J
Using The Integrated Pencil Sharpener (Fig.
6)
A standard pencil sharpener (L) is integrated into the belt hook for the operator’s
convenience. To sharpen a pencil, insert any standard pencil into the hole and rotate
the pencil to the right (clockwise)to sharpen.
Cold Weather Operation
WARNING: Read the section titled Important Safety Instructions
at the beginning of this manual. Always wear eye and ear protection when operating
this tool. Keep the nailer pointed away from yourself and others. For safe operation,
complete the following procedures and checks before each use of the nailer.
When operating tools at temperatures below freezing, complete preparation procedures
outlined above and follow the directions below.
1. Make sure compressor tanks have been properly drained prior to use. Always
drain the compressor tanks at least once daily while using the nailer. This is
especially important in cold weather because any moisture in the air in the tanks
will condense in the cold temperature.
2. Keep the tool as warm as possible prior to use.
3. Lower air pressure to 80 psi or less.
4. Actuate the tool 5 or 6 times into scrap lumber to lubricate o-rings.
5. Turn pressure up to operating level (not to exceed 120 psi) and use tool as normal.
Hot Weather Operation
Tool should operate normally. However, keep tool out of direct sunlight as excessive
heat can damage bumpers, o-rings and other rubber parts.
MAINTENANCE
WARNING: Disconnect air line from tool and remove fasteners from magazine
before making adjustments or personal injury may result.
FIG. 6
L
English
9
Loading ...
Loading ...
Loading ...