Loading ...
Loading ...
Loading ...
Before YouCall ForService... gecom
Troubleshooting -tips
Problem Possible Causes What ToDo
Zoneline does The refit is *Make sure tile Zoneline plug is pushed completely
notstart unplugged, into tile outlet.
The fuse is blown/circuit *(_he(k tile house fllse/circuit breaker box and replace
breaker is tripped, tile filse or reset tile breaker:
The unit is waiting for •This is nomlal, Tile Zoneline will start again after
the compressor overload it resets,
protector to reset.
Power failure.
Zoneline does not cool
or heat as it should
The current interrupter
device is tripped.
Indoor airflow
is restricted.
Outdoor airflow is
restricted or recirculated.
The temp control may
not be set high enough.
The air filter is dirty.
The room may have
been hot or cold.
Outdoor air is
entering the room.
•There is an autoulatic delay stair teature that Inay not
allow tile trait to start, after power is restored and tile
trait is tin'ned back on, fin" approximately 30 seconds.
•There is a protective time delay (up to 3 minutes) to
prevent tripping ot tile compressor overload. For this
reason, the unit may not start nom/al heating or cooling
fi)r 3 ininutes after it is turned back on.
• Press tile RESETbutton located on tile power cord plug
or tile box near tile pltlg.
• If the RESETbutton will not stay engaged, discontinue ttse
of the Zoneline and contact a qtalified sexaice technician.
• Make sure there are no curtains, blinds or flu'niture
bh)cking tile fl'ont ot tile Zoneline.
• Make stu'e tile rear grille is not restricted. This can cause
tile unit to cycle off due to tile compressor overload.
• Outdoor grille umst have a ulininmlu of (35% fl'ee area.
Non-GE grilles inay be too restlJctive fi)r proper
perfi)i_n/ance. (]onsult your salespei_on fi)I" assistance.
• Turn the control to a lower or higher setting.
NOTE: The temperature/imlter may be/imlting the temperature range.
•Clean tile filter at least evely 30 da)s.
See tile OporatiRg hTstructions section.
• When tile Zoneline is fiI_t turned on you need to
allow tiule tor tile I'OOUI 10 COO1 down oi" l_';llIlÀ tlI),
• Set tile vent control to tile C/OSEposition.
Burning odorat the start Dust is on the surface •This can cause a "burning" odor at tile beginning of
of heating operation of the heating element, tile heating operation. This odor should quickly lade.
The air is not always The heat pmnp is not • This is nomlal. The heat pump will produce wmm air
cool or hot during producing hot air. but not as hot as air produced when tile highei_cost
operation electric heat is used.
The fan switch may be
set at continuous fan • This causes tile tim to blow roou/ temperature air
even when the compressor or heater cycles off.
The continuous air movement provides better
overall temperattu'e control.
19
Loading ...
Loading ...
Loading ...