Loading ...
Loading ...
Loading ...
press "-" button to delete the date until you have completed the selection of all dates
· (3) Set the Timer ON time
· Continue to press the "TIMER SET" button, the hour starts blinking
· Press the "+" or "-" button to adjust the hour
· Continue to press the "TIMER SET" button, the minute starts blinking
· Press the "+" or "-" button to adjust minute
· (4) Set the Timer OFF time
· Then press the "TIMER SET" button, the display is off, and the hour starts blinking
· Press the "+" or "-" button to adjust the hour
· Continue to press the "TIMER SET" button, the minute starts blinking
· Press the "+" or "-" button to adjust minute
· (5) Set temperature
· Then press the "TIMER SET" button, and the temperature set starts blinking. At this moment, the temperature displayed is
normally set temperature, which can be adjusted by pressing "+" or "-" button.
· (6) Press "TIMER SET" button to continue setting, and press "OK" complete the setting
Maintenance
· Warning: Before any maintenance and/or cleaning the exterior of the fireplace, disconnect the unit form the
power supply and leave until cooled off.
· Remote control battery replacement: this remote control uses 2x1.5V AAA battery. Make sure the batteries are
installed correctly in the remote control.
· This product does not use a standard bulb for its flame effect. The appliance uses an electronically controlled
LED system to create the flame effect therefore no parts need to be replaced. There are no user-serviceable parts
on this appliance. Under no circumstances should the appliance be serviced by any one other than a qualified
electrician.
Safety Cut-out
· This appliance is fitted with a safety cut-out which will operate if the fire overheats (e.g. Due to blocked air
vents). For safety reasons, the fire will NOT automatically reset.
· To reset the appliance, disconnect the appliance from the mains supply for at least 15 minutes.
Reconnect the supply to the mains and switch on the appliance.
Care and Cleaning
· Always disconnect the appliance from mains supply and allow cooling before any cleaning operation.
· Trim parts may be cleaned using a clean, damp cloth. Never use abrasive cleaners and chemical agents as damage
may occur to the finish.
Technical Specification
Supply: 220-240V~ 50Hz
Rated power: 1800-2000W
Lighting: LEDs
Loading ...