Loading ...
Loading ...
Loading ...
6
6. Install link bar (H, Figure 5-5) onto link stud (E)
clockwise about 15 turns.
Figure 5-5
7. Use any available items to block up foot pedal
to approximately 7-1/2 inches from top of base.
See Figure 5-6. (If stand is secured directly to
floor, measurement will be from floor.)
Figure 5-6
8. Continue turning link bar until top end of link bar
aligns with holes in upper rocker assembly, as
shown in Figure 5-7.
9. Install M8x16 socket head screw and washer
into both ends of pivot assembly, and tighten
screws securely with 6mm hex key.
10. Remove blocking from beneath foot pedal.
Figure 5-7
5.4 Installing jaw sets
Two jaws sets are provided – one for shrinking, one
for stretching.
Figure 5-8
Select both jaws from the same set, and slide them
into frame, as shown in Figure 5-9. Adjust screw if
needed until jaws can be inserted. Top and bottom
jaws are identical, but must have matching
orientation when installed.
Tighten both socket head screws (F) with 6mm hex
key. Make sure jaws remain aligned while
tightening.
Store unused jaws in the attached tray, and hex key
in the attached tube.
Figure 5-9
5.5 Locking pin
When machine is not being used, insert clevis pin
into hole (Figure 5-10). This prevents foot pedal
movement and inadvertent clamping of the jaws.
Figure 5-10
Loading ...
Loading ...
Loading ...