Loading ...
Loading ...
Loading ...
5
Read and understand the entire
contents of this manual before attempting set-
up or operation! Failure to comply may cause
serious injury.
5.0 Setup and assembly
Open shipping container and check for shipping
damage. Report any damage immediately to your
distributor and shipping agent. Do not discard any
shipping material until machine is assembled and
running properly.
Compare contents of your container with the
following parts list to make sure all parts are intact.
Missing parts, if any, should be reported to your
distributor. Read instruction manual thoroughly for
assembly, maintenance and safety instructions.
5.1 Shipping contents
1 Stand assembly
1 Base with wheels
1 Foot pedal
1 Foot pedal axle
4 Socket head cap screws, M10x20
4 Flat washers, M10
1 Spring
1 Link rod
1 Link rod axle
2 Jaw sets
1 Hex key, 6mm
1 Operating Instructions & Parts List
1 Warranty card
5.2 Additional tools required
Hex key, 8mm (not provided)
5.3 Assembly
1. Place base (A, Figure 5-1) on floor, and mount
stand (B) using four M10x20 socket hd. screws
and washers (C). Tighten screws securely.
For more permanent installation, stand may be
secured directly to floor, using lag screws (not
provided) or similar means, through the four
holes.
Figure 5-1
2. Insert foot pedal assembly (D, Figure 5-2) into
stand. Make sure threaded link stud (E) is
pointed toward stand.
3. Continue inserting foot pedal assembly, while
guiding link stud up into recess, as shown in
Figure 5-3.
Figure 5-2
Figure 5-3
4. Align foot pedal pivot shaft with hole in stand,
and insert M10x16 socket head cap screw with
washer (F, Figure 5-4) into each side of hole.
Make sure threaded link stud (E) remains within
recess. Tighten screws securely with 8mm hex
key.
5. Install spring (G, Figure 5-4), first attaching it to
stand, then to foot pedal bar.
Figure 5-4
Loading ...
Loading ...
Loading ...