Loading ...
Loading ...
Loading ...
• Raisethelowerhandlein the direction shown in Figure 2 (step 2) till itsnaps into place.
• Raise the upper handle in the direction shown in Figure 2 (step 3). Tighten the wing nuts which are
already on the handle. See Figure 3A.
Note: Make sure to route the cables inside the lower handle. Also do not crimp the cables while lifting the
handle up.
• For shipping purposes, the hairpin clip is placed in the outer hole of the weld pin on the lower
handle. Remove the hairpin clip from the outer hole of the weld pin.
• Using a pair of pliers, insert the hairpin clip into the inner hole in the weld pin. Repeat on other side.
See Figure 3B.
• Attach the cables to the lower handle with the two cable ties already on the lower handle. Pull tight
the cable ties and cut off the extra. See Figure 3C below.
Ipper Handle
Lower Handle
Tighten
wing nut
A
Move hairpin clip to
this hole
B
Lower
Handle
Cable Tie
C
FIGURE 3
Attaching Starter Rope
The rope guide isalready attached to the right side of the upper handle ofyour mower. See Figure 4.
• With the spark plug wire disconnected and grounded, hold the blade control handle against the
upper handle, and pull the starter rope out of the engine.
• Slip the rope through the rope guide as shown below. Tighten the wing nut holding the rope guide
to the upper handle.
Recoil Wing Nut
Starte__
Upper Handle
Rope _uide
Lower Handle
FIGURE 4
Loading ...
Loading ...
Loading ...