12A-559K402 MTD lawn mower

User Manual - Page 13

For 12A-559K402.

PDF File Manual, 24 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Bagging Grass Clippings
You can use the grasscatcher bag to collect clippings while you are operating the mower. Attach the grasscatcher
following instructions on page 9 of this manual. The grass clippings will automatically collect in the bag as you run
the mower. Operate the mower till the grass bag is full. Do NOT allow the bag to overfill with grass clippings. Stop
the engine completely by releasing the control handle. Make sure that the unit has come to a complete stop. To
empty the grass bag proceed as follows:
Lift discharge door and pull grass bag up and away from the mower to dispose of the grass clippings See
Figure 9.
FIGURE 9
Adjusting Cutting Height
Refer to height adjustments section of this manual on page 16for instructionon how to adjust the cutting height and
the handle height.
For best results in mowing, keep the cutting height position high until it is determined which height is best for
your lawn.
SECTION 8: MAINTENANCE
WARNING: Always stop the engine and disconnect the spark plug wire before performing any
maintenance work or adjustments on your lawn mower.
Cleaning Mower
The underside of the mower deck should be cleaned after each use to prevent any build-up of grass clippings,
leaves, dirt, or other debris, tf this debris is allowed to accumulate, it will result in rust and corrosion.
Disconnect spark plug wire.
Drain the gasoline from the lawn mower, or place a piece of plastic under the gas cap.
Tip the mower so that it rests on the housing. Keep the side with the air cleaner facing UP. Hold the mower
firmly.
Scrape and clean the underside of the deck with a suitable tool. Do NOT spray with water.
Put the mower back on its wheels on the ground. If you had put plastic under the gas cap, make sure to
remove it now.
_lb WARNING: Never tip the mower more than 90 degrees in any direction and do not leave the mowertipped for any length of time. Oil can drain into the upper part of the engine causing a starting problem.
13
Loading ...
Loading ...
Loading ...