Loading ...
Loading ...
Loading ...
10
If the values of systole and diastole fall into two different
WHO categories (e.g. systole in the ‘High normal’ category
and diastole in the ‘Normal’ category), the graphical WHO
classification on the unit always shows the higher category;
for the example given this would be ‘High normal’.
7. Saving, displaying and deleting
measurements
•
The results of every successful measurement are stored
together with the date and time. If there are more than
30 measurements, the oldest measurements are lost.
•
Press the - or + function button. Select the desired user
memory (
... ) by pressing the -/+ function button.
Confirm your selection with the START/STOP button
.
•
If you press the memory button M, the average value of
all the stored measured values in the user memory will be
displayed. If you press the memory button M again, the
average value of the morning measurements for the last 7
days will be displayed. (morning: 5.00 – 9.00, display ).
If you press the memory button M again, the average
value of the evening measurements for the last 7 days will
be displayed. (evening: 18.00 – 20.00, display ). If you
continue to press the memory button M, the most recent
individual measured values are displayed in turn with the
date and time.
•
You can delete the memory by pressing and holding the
memory button M for 3 seconds.
•
To switch off, press the START/STOP button .
•
If you forget to switch off the unit, it will switch off auto-
matically after 1 minute.
8. Error message/trouble shooting
In the event of errors, the error message _ appears on the
display.
Error messages may appear if:
• systolic or diastolic pressure could not be measured (
or
appears on the display)
•
systolic or diastolic pressure was outside the measure-
ment range ( or is displayed),
•
the cuff is fastened too tightly or loosely ( or ap-
pears on the display),
•
the pump pressure is higher than 300 mmHg ( appears
on the display),
•
pumping up takes longer than 160 seconds ( appears
on the display),
•
there is a system or unit error ( , , or appears
on the display),
•
the batteries are almost empty .
In such cases, repeat the measurement. Ensure that you do
not move or speak.
If necessary, reinsert or replace the batteries.
Downloaded from www.ManualsFile.com manuals search engine
Loading ...
Loading ...
Loading ...